KVR16LE11/8HB - KINGSTON TECHNOLOGY

DESCRIPTION

Document No. VAL UERAM1455-001.A00 11/25/14 Page 1

SPECIFICATIONS

Continued >>

kingston.com

FEATURES

ValueRAM's KVR16LE11/8 is a 1G x 72-bit (8GB) DDR3L-1600

CL11 SDRAM (Synchronous DRAM) 2Rx8, ECC, low voltage,

memory module, based on eighteen 512M x 8-bit FBGA

components. The SPD is programmed to JEDEC standard

latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This

240-pin DIMM uses gold contact fingers. The electrical and

mechanical specifications are as follows:

• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~

1.575V) Power Supply

• VDDQ = 1.35V (1.28V ~ 1.45V and 1.5V (1.425V ~ 1.575V)

• 8000MHz fCK for 1600Mb/sec/pin

• 8 independent internal banks

• Programmable CAS latency: 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write (either on the fly using A12 or

MRS)

• Bi-directional Differential Data Strobe

• Internal (self) calibration: Internal self calibration through ZQ

pin (RZQ: 240 ohm ± 1%)

• On Die Termination using ODT pin

• On-DIMM thermal sensor (Grade B)

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°Cº

• Asynchronous Reset

• PCB: Height 1.180” (30.00mm), double sided component

CL(IDD)

Row Cycle Time (tRCmin)

Refresh to Active/Refresh

Command T ime (tRFCmin)

Row Active T ime (tRASmin)

Maximum Operating Power

UL Rating

Operating Temperature

Storage Temperature

11 cycles

48.125ns(min.)

260ns(min.)

35ns(min.)

1.665 W* @1.35V

94 V - 0

0o C to +85o C

-55o C to +100o C

Memory Module Speciﬁ cations

KVR16LE11/8HB

8GB 2Rx8 1G x 72-Bit PC3L-12800

CL11 240-Pin ECC DIMM

SDRAM SUPPORTED

Hynix B-Die