DWG NO. : MSSD-3926 A0
· Input voltage: 90-305VAC
· Built-in ac t i ve PFC f unc tion: 0.99 Typ.
· Low THD: 15% Typ.
· High effici enc y: 89% Typ.
· IP67 design for indoor or outdoor installat ions
· High surge immunity
· Support 0-10V / 10V PWM
· Compliance to worldwide saf ety regulations for lighting
· Suitable for dr y/damp locat ions
Efficiency(120Vac)(Typ.)Note.1
Efficiency(230Vac)(Typ.)Note.1
Voltage Range (V)Note.2
Voltage Rate (V)Note.2
Frequency Range (Hz)
AC Current(Typ.)
Inrush Current(Max.)
Leakage Current(Max.)
Voltage range (V)
Rated Current(mA)
Rated Power (W)
Voltage ADJ. Range ( V)
Ripple&Noise Current( Typ.)
Current Tolerance
Line Regulation
Load Regulation
Current ADJ. Range
Turn on delay Time
Over Current
Short Circuit
Operating Temp.
Tc
Operating Humidity
Storage Temp., Humidity
Temp. Coefficient
Vibration
Safety Standard
Withstand Voltage
Isolation Resistance
EMC Emission
EMC Immunity
MTBF
Lifetime
Dimension
Weight
subject to change without notice
Model
When the inside temperature of PSU rise to 110℃(Typ.), the PSU will shutdown.
The power supply should resume its normal operation when the inside temperature of PSU drop to normal temperature.
Input
(MU096AXXXAQD)
THD(Typ.)
90～305Vac, OR 127~ 431Vdc (Derating may be need under low inputs, Refer to 'Derating Curve' )
100Vac-277Vac
87%
Safety &
EMC
Environment
Protection
Over Voltage(V)
Page 1 of 4
-35~+70℃( Refer to 'Derating Curve' )
90%~110% Protection type : constant current limiting, recovers automatically after fault condition is removed.
32 28
SHA NGHAI MOONS' AUTOMATION CONTROL CO., LTD.
Add: No.168, Mingjia Road, Shanghai 201107, P.R.China
Tel: +86 ( 0) 21 52634688 W ebsite: www.moon s.com.cn
90℃ max
■
Specificati on
■
Features
Power Factor(Typ.)
Others
Output
Over temperature
Protection type: Voltage limiting.output will not excceed the upper limit voltage , recovers automatically after fault condition is removed.
0.86kg
Note.1: Measured at full load and steady-state temperature in 25℃ ambient(Efficiency will be about 2% lower if measured immediately after startup ); Note. 2: Derating may be needed under low input
voltages , Please Refer to 'Derating Curve' ; Note. 3: All parameters NOT specially mentioned are measured at 230VAC input , rated load and 25℃ of ambient temperature ;
<20% with 50%~100% load, at 100Vac～277Vac
1.2A at 100VAC input, 0.6A at 230VAC
50A at 230Vac input 25℃ Cold Start ( time wide=500uS, measured at 50% Ipeak,Not applicable for the i nr ush current to Noi se F ilter for less than 0.2ms)
0.75mA at 277Vac/60Hz
±1%
±3%
300,000 Hours,measured at full load,25℃ ambient temperature
50,000 Hours at Tc 75℃(Refer to"Life Time VS. Tcase (Ref.)")
10-500Hz,5G 12min/cycle，period for 72min each along X、Y、Z axes
47~63
0.99 (Typ.) with 80%~100% load,at 120Vac
0.96 (Typ.) with 80%~100% load,at 230Vac
>0.9 with 80%~100% load,at 277Vac
<15% with 80%～100% load, at 100Vac～277Vac
≤10%((PK-AV) /AV) with LED default mode and full load)
-
<3s, at 120Vac; <1.5s, at 277Vac
Constant current limiting, recovers automatically after fault condition is removed.
UL8750, UL1012, UL1310 Class 2,CSA-C22.2 No. 107.1, CSA C22.2 NO. 223-M91 Class 2,EN61347-1, EN61347-2-13
±5%
201 x 67.5 x 37 mm（LxWxH）
I/P-O/P:3.75KVac O/P-FG:1.5KV
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500Vdc/25℃/70%RH
EN55015/FCC Part 15 , EN61000-3-2 C lass C, EN 61000-3-3
EN61000-4-2,3,4,5,6,8,11（Surge L,N-FG 6KV ，L-N 4KV），EN61547
20~95%RH
-40~+80℃，10-95%RH
0.03%/℃（0~50℃）
87%
175 210 245 280 315 357
85% 85% 84% 84%
420
89% 88% 88% 88% 87% 84%
55 46 39 34 30.5 27 23
86% 85%
2100 2450 2800 3150 3570 4200
96 96 96 96 96 96
22~46 19~39 17~34 15~30.5 13~27 12~23
1750
96
27~55
MU096AxxxAQD Series General - Outdoor
60 51 42.4 39 36
DWG NO. : A0
Derating Curve
Power Fact or VS. L oad Curve
Life T ime VS. T case ( Ref .)
subject to change without notice
THD Curve
Page 2 of 4
SHANGHAI MOONS' AUTOMATION CONTROL CO., LTD.
Add: No.168, Mingjia Road, Shanghai 201107, P.R.China
Tel: +86 (0)21 52634688 Website: www.moons.com.cn
MU096AxxxAQD Series General - Outdoor
MSSD-3926
Efficiency VS. Load Curve
A0
Dimming function description:
1.The dimmer control may be operated from an input signal of 0 - 10 Vdc / 10V PWM
（
Frequency range:500Hz to 5KHz,Duty:0-100%
）
.
2.With one external variable resistor,the VR value must not be less than 113.3Kohm.
Dimming module diagram and dimmi ng cruve:
Dimming connection diagram:
Notes:
1.Io is actual output current with dimming control signal and Ir is rated output current.
2The dimming control signal can be operated output current from 100% to 10% Ir,output voltage must be maintained
above 50% of the rated output voltage.
3.Do not connect dimming wire to the output;otherwise,the LED driver can not work normally.
4.The dimming signal is allowed to be less than 1V/10% PWM ,the output current can be maintained 10% Ir.
(about on/off function specification ,please contact MOONS for details).
SHANGHAI MOONS' AUTOMATION CONTROL CO., LTD.
Add: No.168, Mingjia Road, Minbei Industrial Park, Sha ngha i 201107, P.R.China
Tel: +86 (0)21 52634688 Website: www.moons.com.cn
Value of Rin ( the resistor inside the LED driver
which locate between the DIM+ and the DC 19.8k 20k 20.2k
subject t o c ha nge w ithout notice Page 3 of 4
Absolute maximum voltage on the DIM+ -2V -12V
Source current on the DIM+ 0 mA -0.5 mA
DC supply output voltage 8V 10V 12V
DC supply output source current 0 mA -10 mA
Dimming Control Module Parameter(On secondary side)
Parameter Min. Typ. Max. Notes
MU096AxxxAQD Series
General - Outdoor
DWG NO. : MSSD-3926
DWG NO. : MSSD-3926 A0
RoHS Compliance:
Our product s c omply with the E ur opean Dir ec tive 2002/ 95/EC, calling f or t he eli mination of lead and other hazardous subst anc es from electronic produc ts.
Page 4 of 4
SHANGHAI MOONS' AUTOMATION CONTROL CO., LTD.
Add: No.168, Mingjia Road, Shanghai 201107, P.R.China
Tel: +86 (0)21 52634688 Website: www.moons.com.cn
subject to change without notice
MU096AxxxAQD Series General - Outdoor
■ Mechanical Specification
Dimensions(Unit:mm)
