Series 107-51 Aluminum Extractor SERIES 107-51 ALUMINUM INSERTER / EXTRACTOR MATERIALS AND FINISH EXTRACTOR Materials: Aluminum alloy 6061-T6 Finish: Black anodize per Mil-A-8625, Class 2, Type II or Clear Chemical Film per Mil-DTL-5541, Class 3, Type II for a conductive finish. 2.77 (.109) 7.24 .38 (.285 .015) 6.35 (.250) 1.5 (.06)Ref. Card Guide Surface 9.1 (.36) 1.5 (.06)max. ASSEMBLY PIN Materials: Stainless steel Finish: Passivated 6.1 (.24)min. 6.35 (.250) 12.7 (.50) APPLICATION DATA Two inserter or inserter-extractors are recommended per printed circuit board taller than 127 mm (5 in) height. Assembly Pin 3.96 (.156) R ASSEMBLY PIN Option to be pre-started for: * Faster and easier installation of the extractor to the PCB * Eliminates the need for special tools or equipment and set up time. * Eliminates loss of loose assembly pins If the "P" option is not selected, the extractors and the pins will be packaged seperately. 18.5 (.73) 38.1 (1.50) 12.06 (.475) 51 7.37 (.290) P C Units: mm (in) [blank] .xx .25, .x .5 (.xxx .010, .xx .02) Finish [blank] C [blank] 3 C extractor ec thickness of 2.4 (.094) 51 Series 107- for PCB nVent.com/SCHROFF1-800-854-7086 nVent may modify standard parts without prior notice to or approval from customers. These modifications may change product appearance, but will not have a detrimental effect on form, fit or function. (c)2018 nVent. All nVent marks and logos are owned or licensed by nVent Services GmbH or its affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without notice.