Issued 9-99 2-PACK 2mm HM Connactors (Continued) Guiding Hardware (Continued) Static Discharge Guide Pins Ra Ground connection and guidance can be combined using this system which can be used instead of the guide pins shown on page 230. The contacts have a rating of 10A and givea maxe/break position 12mm [.472] in advance of level 3 signal contacts. 5 Alternative pin iengths are possible and the pin comtact housing can be omitted if desired. Materials and Finish Housings Glass fillad polyester gray, UL94 V-0 rating Contacts Pin Brass Receptacle Copper alloy Plating, 0.8m Au in contact area wo x S t=] = @ 7) < & 2 3 VAL wo over 0.8m min Ni 4 = = @ 3 = 1 Sei 2.00 3D [079] Ta standard hole cD pattern for signal 3 p4q--------- _ module S | | 8 I 1 +e go | * [318] i S 1 : +q t Receptacle ite Housing Layout | + I 98, 7 oh * +0 2 TH 1 +a [.059] * 1 S pe of 2.5 Pt board 6 0.53 [,021] [.098] Finished hole ~ {0.70mm drill hole) 9.60 r* [386] 8.00 - [415] 7 2.00 ty standard hols L073] pate torsiynal module 1 *e 1 + 2.08 pi $ . [079] ati, Pin if rT Housing Layout | | l +b Part Numbers I ' Pin Contact 5328285 +a Pin Gontact Housing __646274-1 I Receptacle Contact 39065-6 po} -__|- ee 1 Rec Contact Housing 646273-1 Nut 21124-4 Washer 986794-1 80.53 [021] _ Rms. Finished hole (0.70mm drilt hele} Networking AMP Technical Suppart Cantar/AMP FAX Service Dimensions are In www.amp.com Specifications 237 1-600-522-6762 717-986-7777 millimeters over [inches] subject to change.