Metal Plasterboard Plug Pack of 100 Description: pecially designed zinc die-cast plug for use in plasterboard, chipboard, aerated S concrete etc. To install, simply drill a pilot hole and screw the plug into the wall with a Phillips or Pozidriv driver. The object to be mounted is then screwed into the back of the plug as with a normal wall plug. For best results ensure screw length is 20mm more than the thickness of the object to be mounted. Features: * * * * * Specially designed cutting tip for quick installation into plasterboard Supplied with No. 6 x 35mm (1 3/8") pozi driv roundhead screws Alternative screws (6-10 gauge) can be used if required for different fixtures The overall length of the plug is 38mm with a maximum screw penetration of 25mm (1") Supplied in packs of 100 Specifications: External Length / Height Material Suitable Screw : 35mm : Metal : 6-10 Part Number Table Description Part Number Plasterboard Speed Plug-Metal (PK100) MSP420 Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. DURATOOL is the registered trademark of the Group. (c) Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com www.cpc.co.uk www.mcmelectronics.com Page <1> 28/08/14 V1.0