Temperature Sensor Thermo String Type !Caution/Notice and Package
c !Caution (Storage and Operating Conditions)
This product is designed for application in an
ordinary environment (normal room temperature,
humidity and atmospheric pressure).
Do not use under the following conditions because
all of these factors can deteriorate the product
characteristics or cause failures and burn-out.
1. Corrosive gas or deoxidizing gas
(Chlorine gas, Hydrogen sulfi de gas, Ammonia gas,
Sulfuric acid gas, Nitric oxide gas, etc.)
2. Volatile or fl ammable gas
3. Dusty conditions
4. Under vacuum, or under high or low pressure
5. Wet or humid locations
6. Places with salt water, oils, chemical liquids or
organic solvents
7. Strong vibrations
8. Other places where similar hazardous conditions
exist
c !Caution (Others)
c Notice (Storage and Operating Conditions)
To keep solderability of product from declining, the
following storage condition is recommended.
1. Storage condition:
Temperature -10 to +40 degrees C
Humidity less than 75%RH (not dewing condition)
2. Storage term:
Use this product within 6 months after delivery by
fi rst-in and fi rst-out stocking system.
3. Handling after unpacking:
After unpacking, reseal product promptly or
store it in a sealed container with a drying agent.
4. Storage place:
Do not store this product in corrosive gas
(Sulfuric acid gas, Chlorine gas, etc.) or in direct
sunlight.
c Notice (Rating)
c Notice (Handling)
c Notice (Soldering and Mounting)
R44E.pdf
Jan.10,2012
28
!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifi cations because there is no space for detailed specifi cations. Therefore, please review our product specifi cations or consult the approval sheet for product specifi cations before ordering.
5
Please note as shown below when you mount this product.
1. Do not melt solder in the resin head when you solder
this product. If you do so, it has a possibility of wire break,
electric short mode failure and wire coating break.
In case you cut the lead wire of this product less than
20mm from the resin head, the heat of the melted solder
at the lead wire edge is propagated easily to the resin
head along the lead wire.
2. Do not touch the resin head directly with the soldering
iron. It may cause the melting of solder in the resin head.
3. Do not separate the parallel lead wires 10mm or less
from the resin head, when you separate parallel lead
wires.
4. If you mold this product by resin, please evaluate
the quality of this product before you use it.
5. Do not bend the lead wire radius 1mm or less when
you bend the lead wire.
1. The ceramic element of this product is fragile, and
care must be taken not to load an excessive
press-force or not to give a shock at handling.
Such forces may cause cracking or chipping.
2. Do not apply an excessive force to the lead.
Otherwise, it may cause junction between lead and
element to break or crack. Holding element by side
lead wire is recommended when lead wire is bent or
cut.
Be sure to provide an appropriate fail-safe function
on your product to prevent secondary damages that may be
caused by the abnormal function or the failure of our
product.
Use this product within the specifi ed temperature
range.
Higher temperature may cause deterioration of the
characteristics or the material quality of this
product.
Minimum Order Quantity
Part Number Minimum Quantity (pcs.)
Bulk
NXFT 1,000