Module no:1640786 LabelId:1640786 Operator:Phoenix 15:56:02, Donnerstag, 28. Juni 2001
SACC-VQ-3CON0,75...
Valve plug connector for 0.34 – 0.75 mm2
Description
Valve plug connector, 4-pos.
without, wiring
Valve plug connector, 3-pos.
with LED (yellow)
Valve plug connector, 3-pos.
with varistor and LED (yellow)
Valve plug connector, 3-pos.
with rectifier, varistor and LED
(yellow)
Valve plug connector, 3-pos.
with pole protection damping diode
and LED (yellow)
Valve plug connector, 4-pos.
Power amplifier with LED (red)
and Z-diode,Coil current max.
Control current Ie≤3 mA
Nom.
current
[A]
6
6
6
6
6
1
1
1
1
2
Voltage
[V]
0-250 V AC/DC
12-24 V AC/DC2)
12-24 V AC/DC2)
100-120 V AC/DC
200-240 V AC/DC
12-24 V AC/DC
100-120 V AC/DC
200-240 V AC/DC
12-24 V DC
18-36 V DC
Type
SACC-VQ-3CON0,75-A
SACC-VQ-3CON0,75-A-L12/24
SACC-VQ-3CON0,75-A-VL12/24
SACC-VQ-3CON0,75-A-VL100/120
SACC-VQ-3CON0,75-A-VL200/240
SACC-VQ-3CON0,75-A-GVL12/24
SACC-VQ-3CON0,75-A-GVL100/120
SACC-VQ-3CON0,75-A-GVL200/240
SACC-VQ-3CON0,75-A-PFL12/24
SACC-VQ-4CON0,75-A-VER
Order No.
16 40 78 6
16 40 81 2
16 40 82 5
16 40 92 2
16 40 85 4
16 40 90 6
16 40 91 9
16 40 88 3
16 40 89 6
16 40 79 9
Pcs.
Pkt.
1
1
1
1
1
1
1
1
1
1
Accessories
Allen wrench,
to tighten and release the
QUICKON union nut
Closing cap,
for closing unoccupied
connections
Locking nut,
can only be released with
wrench (not for SACC...VER)
PG 13,5/SW 24
wrench size 24
QSS 22
QSS 24
QPROT 9/11
QPROT 13/16
Q-SMU PG 13,5 SET
16 70 20 6
16 70 21 9
16 70 23 5
16 70 22 2
16 70 75 6
1
1
10
10
1
Technical data
Number of positions
Power data
Cross section range of the cores
Struct. of indiv. litz acc. to VDE 0295 /
smallest wire cross sect.
Core insulation material
Core cross section (with insulation)
Outer diameter of conductor
[mm2]
[mm]
[mm]
[mm]
3 (2+PE), 4 (3+PE)
0.34 - 0.75
class 2 bis 5 / 0.2
PVC / PE
≤2.5
3.5 - 6.5 (4 - 7 bei SACC...VER)
Phoenix Contact Elektronischer Katalog Page 1 / 2
Module no:1640786 LabelId:1640786 Operator:Phoenix 15:56:02, Donnerstag, 28. Juni 2001
Torque of union nuts
Environme conditions
Protection type
(IEC 60 529 / EN 60 529 / DIN VDE 0470-1)
Ambient temperature
Temperature when conductor is connected
Electrical characteristics
Nominal current
(ambient temperature: 40 °C)
Rated voltage
Surge voltage category / contamination class
LED (operating indicator)
Mechanical characteristics
Frequency of the connection of a conductor of same
cross section
Material data
Contact material
Contact surface
Insulation material / Inflammability class
in acc. with UL 94
[mm]
[°C]
[°C]
[A]
[V AC]
()
2.5
IP 65
– 25 bis + 80 (– 10 bis + 70 with SACC...VER)
-25 to +505)
see above
see above
III / 3
yellow (SACC...VER: red)
104)
CuSn alloy
Ag
PA 6.6 / HB
1) Screwdriver groove facilitates turning the insert.
2) With alternating voltage (AC) only one half-cycle is available for the LED.
With 12 V AC, the power is not sufficient to make the LED light up fully.
3) Dependent on conductor cross section.
4) Before renewed use, it may be necessary to replace seal and cap.
5) Specifications of the cable manufacturer must also be observed.
Note:
Plug connectors may only be operated when under no load.
Phoenix Contact Elektronischer Katalog Page 2 / 2
