APE
■Right angle terminals
■Button Shape
Standard(M)
■Mounting of Switch
●Use PC boards with hole diameter of 1mm.
●Do not bend the terminal pins before mounting the switch on
the PC board.
●After mounting the switch, do not place the device in such a
way that the device weight will be applied on to the actuator of
the switch.
●Do not apply load exceeding 12.7 N to the actuator. If load
exceeding 12.7 N is expected to be applied to the actuator,
please use a Bracket (optional accessory sold separately).
Maximum load will be 29.4 N when a Bracket is used.
●Use Bracket 140000640314 or 140000640318 for side-by-
side mounting.
●To increase mounting strength, use Bracket
140000640315.
●PC Hole Layouts will change depending on the Bracket.
Please refer to P.245.
■Bracket Installation Procedure
1 pole
2 poles
●The space between the terminal rows are available in
two dimensions: 0.2 inches (5.08 mm) and 0.3 inches
(7.62 mm).
[Example] 0.2-inch pitch : APE1F-5M-10-Z
0.3-inch pitch : APE1F-6M-10-Z
■Color Cap Mounting
Refer to P.249.
:Optional Accessories.