PRODUCT DATASHEET 1-800-383-7323 USA/CAN www.energizer.com ENERGIZER 377/376 SILVER OXIDE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Industry Standard Dimensions mm (inches) Silver Oxide (Zn/Ag2O) ANSI/NEDA-1176SO, IEC-SR66 1.55 Volts 24 mAh* (to 1.2 volts) 47K ohm continuous drain at 21C 0.42 grams (0.015 oz.) 0.09 cubic centimeters (0.0063 cubic inch) 15 to 30 ohms * Varies according to the applied load, temperature, and cutoff voltage. 3.00 (0.118) Minimum 6.80 (0.268) 6.60 (0.260) Cross Section 2.60 (0.102) 2.40 (0.094) 2.57 (0.101) Ref. 2.31 (0.091) Ref. R0.90 (0.035) Ref. Typical Anode Cap Gel Anode 0.13 (0.005) Maximum Ref. Permissible defelction from a flat Gasket Can Separator 0.06 (0.002) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN HIGH PULSE ON DEMAND Typical Discharge Characteristics Temperature Characteristics Typical Performance at 21C (70F) Typical Performance at Low Discharge Rates Service Effects Service (%) 125 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 100 75 50 25 0 -20 0 20 40 Temperature (C) 0 150 300 450 600 750 Service, Hours Schedule Typical Drains at 1.46V (milliamperes) (ohm) Cutoff 1.2V (hours) 0.031 47K 773 Continuous Load Storage Effects 900 100 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.46V: 0.031 milliamperes Load: 47K ohm 0C 90 20C 80 70 40C 60 0 2 4 6 8 10 12 Storage Time (yrs) Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. (c)Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4364-ZN Page 1 of 1