D-30 DC Deltrol CONTROLS D-FRAME SOLENOID Two position linear solenoid with D-frame construction. Features * Balance of cost and performance * AC solenoids and DC solenoids available * Encapsulated coils on most models * UL approval on many models Electrical Specifications Coil Voltages 6, 12, 24, 120, 240 VAC | 6, 12, 24, 110 VDC Coil Power 13 VA Continuous, 37 VA Intermittent, 120 VA Pulse 8.5 Watts Continuous, 21 Watts Intermittent, 85 Watts Pulse Coil Termination .187" quick connect terminals (standard) Wire leads optional with tape wrapped coil Duty Cycle Continuous, intermittent and pulse duty available (see standard part numbers on page 4) Coil Treatment Encapsulated (tape wrapped optional) Insulation Class Class A Rating - 105C (221F) Max. (standard) Class F Rating - 155C (311F) Max. (optional) Dielectric Strength 30 Volts and Under: 500 VRMS Over 30 Volts: 1000 VRMS plus 2X rated voltage for 1 minute Mechanical Specifications Size 2.015" (L) x 1.000" (W) x 1.218" (H) (See page 2 for dimensional drawing) Forces See force curves on page 3 Plunger Diameter 0.4375" Plunger Guide Material Plastic Mounting 2X #8-32 UNC-2B Mounting Holes Weight Plunger - 1.06 oz., Total - 7 oz. Life Expectancy 250,000 Cycles (Dependent on load conditions) Agency Approval UL File No. E57982 For Continuous Duty UL File No. E74443 For Insulation Systems S105, S130, S130D, S130D1, S155D All dimensions in Inches Specifications subject to change without notice 1 of 4 Rev 07/18/11 (c)2011 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 414.671.6809 | www.deltrol-controls.com| sales@deltrol.com D-30 DC Deltrol CONTROLS Dimensional View Units: Inches [mm] UNLESS OTHERWISE SPECIFIED INCHES .015 (MILLIMETERS 0.38) Specifications subject to change without notice 2 of 4 Rev 07/18/11 (c)2011 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 414.671.6809 | www.deltrol-controls.com| sales@deltrol.com D-30 DC Deltrol CONTROLS Force Curves AC Continuous Duty - 13 VA DC Continuous Duty - 8.5 Watts AC Intermittent Duty - 37 VA DC Intermittent Duty - 21 Watts AC Pulse Duty- 120 VA DC Pulse Duty - 85 Watts Standard intermittent duty cycle at nominal voltage is 25%, with three (3) minutes maximum "ON" and nine (9) minutes minimum "OFF" in a repetitive cycle. Standard Pulse duty cycle is 10% with 100 milliseconds "ON" and 900 milliseconds "OFF". NOTE: Approx 36 sq. in. Heat Sink Required Specifications subject to change without notice 3 of 4 Rev 07/18/11 (c)2011 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 414.671.6809 | www.deltrol-controls.com| sales@deltrol.com D-30 DC Deltrol CONTROLS Standard Part Numbers Duty Cycle Voltage 53748-80 6 VAC 0.41 53748-81 12 VAC 1.65 53748-82 24 VAC 53748-84 120 VAC 172 53748-85 240 VAC 700 53748-87 12 VAC 0.871 Continuous Power Resistance (Ohms) Parts No. 13 VA 6.71 53748-88 24 VAC 53748-90 120 VAC 53748-91 240 VAC 353 53748-93 12 VAC 0.43 53748-94 24 VAC 53748-96 120 VAC 53748-97 240 VAC 182 53749-80 6 VDC 4.27 Intermittent Pulse 37 VA 120 VA 3.78 86.2 1.73 45.5 53749-81* 12 VDC 53749-82* 24 VDC 53749-84 110 VDC 1470 53749-86 6 VDC 1.65 53749-87* 12 VDC 53749-88* 24 VDC 53749-90 110 VDC 538 53749-92 6 VDC 0.41 53749-93 12 VDC 53749-94 24 VDC 53749-96 110 VDC Continuous Intermittent Pulse 8.5 Watts 21 Watts 85 Watts Operation 17.7 69.8 6.71 26.8 1.65 6.71 Typical Force (oz). 100% Voltage, 77, Stroke @ 0.000" 0.125" 0.250" 0.500" 0.750" Pull 65 16.5 13 11 0 Pull 108 29 21 17 0 Pull 176 55 40 33 0 Pull 110 28 15 6 0 Pull 133 58 40 16 0 Pull 185 115 97 55 23 148 (*) Normally Stocked Non stocked items require a minimum order Specifications subject to change without notice 4 of 4 Rev 07/18/11 (c)2011 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 414.671.6809 | www.deltrol-controls.com| sales@deltrol.com