PS-75 DC Deltrol CONTROLS D-FRAME SOLENOID Two position linear solenoid with D-frame construction. Features * Balance of cost and performance * DC solenoids available Electrical Specifications Coil Voltages 6, 12, 24, 28, 32, 36, 48, 90, 115 VDC Coil Power 150 Watts Continuous Coil Termination Wire leads (standard) Duty Cycle Continuous Coil Treatment Tape Wrapped Insulation Class Class A Rating - 105C (221F) Max. (standard) Dielectric Strength 30 Volts and Under: 500 VRMS Over 30 Volts: 1000 VRMS plus 2X rated voltage for 1 minute Mechanical Specifications Size 2.625" [66.7] (L) x 1.562" [39.7] (W) x 1.828" [46.4] (H) (See page 2 for dimensional drawing) Forces See force curves on page 2 Plunger Diameter O 0.500" [12.7] Plunger Guide Material Brass Mounting 6X #8-32 UNC-2B Mount Holes Weight Plunger - 1.9 oz [53.9 gms], Total - 19.0 oz [538.7 gms] Life Expectancy 250,000 Cycles (Dependent on load conditions) Agency Approval Dimensions: inches [mm] Specifications subject to change without notice 1 of 4 Rev 05/09/12 (c)2012 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 4 14.671.6809 | www.deltrol-controls.com| sales@deltrol.com PS-75 DC Deltrol CONTROLS Dimensional View Units: Inches [mm] UNLESS OTHERWISE SPECIFIED INCHES .015 (MILLIMETERS 0.38) Specifications subject to change without notice 2 of 4 Rev 05/09/12 (c)2012 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 4 14.671.6809 | www.deltrol-controls.com| sales@deltrol.com PS-75 DC Deltrol CONTROLS Force Curve Schematic (With plunger at 0 stroke) Specifications subject to change without notice 3 of 4 Rev 05/09/12 (c)2012 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 4 14.671.6809 | www.deltrol-controls.com| sales@deltrol.com PS-75 DC Deltrol CONTROLS Standard Part Numbers Parts No. Voltage Duty Cycle Power Resistance (Ohms) 51073-80 6 VDC 0.24 Pull 2.75 Hold 51073-81* 12 VDC 0.96 Pull 11 Hold 51073-83* 24 VDC 3.84 Pull 44.2 Hold 51073-85 28 VDC 5.2 Pull 60 Hold 51073-87 32 VDC 51073-88 36 VDC 8.6 Pull 99 Hold 51073-89 48 VDC 15.4 Pull 176.6 Hold 51073-90 90 VDC 54 Pull 620 Hold 51073-93 115 VDC 88 Pull 1020 Hold Continuous 150 Watt Operation 6.8 Pull 78.6 Hold Pull Typical Force oz [N] 100% Voltage, 77F [25C], Stroke @ 0.000" 0.125" 0.250" 0.500" 0.750" 200 [55.6] 250 [69.5] 205 [57.0] 125 [34.8] 80 [22.2] (*) Normally Stocked Non stocked items require a minimum order Specifications subject to change without notice 4 of 4 Rev 05/09/12 (c)2012 Deltrol Controls - A Division of Deltrol Corp. 2740 South 20th Street Milwaukee, WI 53215 USA | P: 414.671.6800 | F: 4 14.671.6809 | www.deltrol-controls.com| sales@deltrol.com