1
2
4
Vref
ST-BY 7
IN1
C1 0.22µF
VCC
133
D98AU833A
+
-
-
+
OUT1+
OUT1-
MUTE 68
9
S-GND
PW-GND
C5
470µFC6
100nF
R1 10K
C2
10µF
µP
R2 10K
C4
1µF
Figure 1: Microprocessor Application
ELECTRICAL CHARACTERISTICS (Continued)
Symbol Parameter Test Condition Min. Typ. Max. Unit
VTST-BY St-by Threshold 0.8 1.3 1.8 V
IST-BY ST-BY current V6 = GND 100 µA
eNTotal Output Noise Voltage A curve
f = 20Hz to 20kHz 150 µV
APP LICATION SUG GES TION
STAND-BY AND MUTE FUN C TION S
(A) Microprocessor Applicatio n
In order to avoid annoying "Pop-Noise" during
Turn-On/Off transients, it is necessary to guaran-
tee the right St-by and mute signals sequence.
It is quite simple to obtain this function using a mi-
croprocessor (Fig. 1 and 2).
At first St-by signal (from mP) goes high and the
voltage across the St- by t erminal (Pin 7) s tarts to
increase exponentially. The external RC network
is intended to turn-on slowly the biasing circuits of
the amplifier, this to avoid "POP" and "CLICK" on
the outputs.
When this voltage reaches the St-by threshold
level, the amplifier is switched-on and the external
capacitors in series to the input terminals (C3,
C5) start to charge.
It’s necessary to mantain the mute sign al low until
the capacitors are fully charged, this to avoid t hat
the device goes in play mode causing a loud "Pop
Noise" on the speakers.
A delay of 100-200ms between St-by and mute
signals is suitable for a proper operation.
TDA7266M
3/9