Silicon Miniature Single-Phase Bridge COMCHIP www.comchiptech.com AM 100/150 Thru AM1010/1510 Voltage: 50 - 1000 Volts Current: 1.0 - 1.5 Amp AM Features Ratings to 1000V PRV Surge overloadrating - 30/50 amperes peak Ideal for printed circuit board Reliable construction utilizing molded plastic Mounting position: Any Mechanical Data Case: Reliable low cost construction utilizing molded plastic technique results in inexpensive product Terminals: Lead solderable per MIL-STD-202, Method 208 Polarity: Polarity symbols marking on body Weight: 0.05 ounce, 1.3 grams Available with 0.50 inch leads (P/N add suffix "S") MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25C ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, Resistive or inductive load. For capacitive load, derate current by 20%. Maximum Recurrent Peak Reverse Voltage Maximum RMS Bridge input Voltage Maximum DC Blocking Voltage AM100 Maximum Average Forward Rectified AM100 Current at T A = 50C AM150 Peak Forward Surge Current, 8.3ms single half AM100 sine-wave superimposed on rated load AM150 Maximum Forward Voltage Drop per Bridge Element at 1.0A DC Maximum Reverse Current at Rated T A = 25C DC Blocking Voltage per element T A = 100C AM100 AM150 50 35 50 AM101 AM151 100 70 100 AM102 AM152 200 140 200 AM104 AM154 400 280 400 1.0 1.5 30 50 AM106 AM156 600 420 600 AM108 AM1010 UNITS AM158 AM1510 800 1000 V 560 700 V 800 1000 V A A 1.0 V I2t Rating for fusing ( t< 8.35ms) Typical Junction capacitance per leg (Note 1) CJ Typical Thermal resistance per leg (Note 2) RJA Typical Thermal resistance per leg (Note 2) RJL Operating Temperature Range T J 10.0 1.0 10 24 36 13 -55 to +125 uA mA A2S pF Storage Temperature Range T A -55 to +150 C/W C C NOTES: 1. Measured at 1 MHz and applied reverse voltage of 4.0 Volts 2. Thermal resistance from junction to ambient and from junction to lead m ounted on P.C.B. with 0.47x 0.47"(12 x 12mm) copper pads MDS0306001A Page 1 Silicon Miniature Single-Phase Bridge COMCHIP www.comchiptech.com Rating and Characteristic Curves (AM100/150 T HRU AM1010/1510) 40 30 AM150 SERIES 20 10 AM100 SERIES 0 2 4 6 10 20 40 60 100 OUTPUT CURRENT AMPERES FORWARD SURGE CURRENT, AMPERES pk(HALF SINE-WAVE) 50 2.0 AM150 SERIES 1.5 AM100 SERIES 1.0 0.5 0 0 50 100 150 NUMBER OF CYCLES AT 60Hz AMBIENT TEMPERATURE,C Fig. 1-MAXIMUM NON-REPETITIVE SURGE CURRENT Fig. 2-DERATING CURVE FOR OUTPUT RECTIFIED CURRENT 4 3 2 1 .9 .8 .7 .5 .3 TYPICAL DISTRIBUTION .2 .1 .07 .05 .03 .02 MEDIAN .01 0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 INSTANTANEOUS REVERSE CURRENT, MICROAMPERES INSTANTANEOUS FWD CURRENT, AMPERES 5 10 T A = 100C 1.0 T A = 25 C .1 .01 0 20 40 60 80 100 120 140 INSTANTANEOUS FWD VOLTAGE, VOLTS PERCENT OF PEAK REVERSE VOLTAGE Fig. 3-TYPICAL FORWARD CHARACTERISTICS(25 C) Fig. 4-TYPICAL REVERSE CHARACTERISTICS MDS0306001A Page 2