Instruction Sheet Storage Maintenance for Mass Termination Assembly (MTA)- 100 and - 156 Connector Strain Relief Covers Made with Polyamide PRODUCT IS MOISTURIZED DO NOT OPEN BAG UNTIL TIME OF USE PRODUCT WEIGHT 408-- 10313 31 JUL 09 Rev A AMOUNT OF DI WATER TO ADD Pound (lb) (See Note) Cubic Centimeters (cc) Pound (lb) 01 011 .025 02 023 .050 03 034 .075 04 045 .100 05 056 .125 1. INTRODUCTION 06 068 .150 Proper storage of product must be maintained according to the instructions given by the distributor or supplier. 07 080 .175 08 091 .200 09 103 .225 10 114 .250 11 125 .275 2. DESCRIPTION 12 136 .300 Product is contained in a polyethylene bag. For product to be functional, make sure that the following applies: 13 148 .325 14 159 .350 15 170 .375 16 181 .400 17 193 .425 18 204 .450 19 215 .475 20 226 .500 21 238 .525 22 250 .550 1. Using a scale, weigh the product in the bag. 23 261 .575 2. Refer to the table on this page to determine the amount of DI water to add to the bag. 24 273 .600 25 284 .625 3. Spray the DI water into the bag until the targeted weight is achieved. 26 295 .650 27 306 .675 28 318 .700 29 329 .725 30 340 .750 31 351 .775 32 363 .800 RESEAL BAG IMMEDIATELY AFTER EACH USE To Avoid Hydration of Product, Bag Must Have A Targeted Moistured Content Between 2 and 3% of Weight Proper hydration of product must be maintained according to these instructions. -- the bag must have a target moisture content between 2 and 3% of weight -- the bag must be completely sealed If a bag containing product has a moisture content of less than 2% of weight, the bag must be re--hydrated with deionized (DI) water (or distilled water) before returning product to storage. 3. RE- HYDRATING INSTRUCTION 4. REVISION SUMMARY S Initial release of instruction sheet Note: Round product weight to nearest whole pound. TOOLING ASSISTANCE CENTER 1-- 800-- 722-- 1111 E2009 Tyco Electronics Corporation, Harrisburg, PA PRODUCT INFORMATION 1-- 800-- 522-- 6752 All International Rights Reserved TE logo and Tyco Electronics are trademarks. *Trademark. Other products, logos, and company names used are the property of their respective owners. This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.tycoelectronics.com 1 of 1 LOC B