K M Y Drawing No: RH−K−HTS−0001 /2
Title: FIXED HIGH VOLTAGE RESISTORS: PRECISION
RH1, 2, 3, 4, 6, 8 Page: 5/6
Product specification contained in this specification are subject to change at any time without notice.
If you have any questions or a Purchasing Specification for any quality agreement is necessary, please contact our sales staff.
Issue: KAMAYA ELECTRIC CO., LTD. Research & Development Department HOKKAIDO Research center Last update: 2012.8.30
7. Performance
7.1 The standard condition for tests shall be in accordance with Sub−clause 3, JIS C 5202−1990.
7.2 The performance shall be satisfied in Table−5.
7.3 The following three performance (*3) shall not be applied to the use in insulation oil.
• No.4 Insulation resistance, No.5 Dielectric withstanding voltage, No.11 Humidity (Steady state)
Table−5(1)
No. Test items Condition of test (JIS C 5202) Performance requirements
1 DC resistance Paragraph 5.1
Measurement voltage: 100Vdc
Period: Within 5s
Within the specified tolerance of
nominal resistance.
2 Temperature characteristic
of resistance
Paragraph 5.2
The resistance shall be measured at the room
temp. and temp. about 80°C higher than the
room temp.
See Table−1
3 Short time overload Paragraph 5.5
Test potential: 2.5 times rated voltage.
Test period: 5s.
Test potential should not exceed max. overload
voltage as shown in Table−1.
Within ±(1%+0.05Ω)
No evidence of appearance
damage.
4 Insulation resistance
*3
Paragraph 5.6
Test condition: A
Test potential:500Vdc.
Test period: 1min.
1000MΩ min.
5 Dielectric withstanding
voltage
*3
Paragraph 5.7
Test condition: A
Test pressure: Normal pressure
Test potential: 500Vac
+10
Test period:60 s
0
No flashover, fire and breakdown.
6 Pulse test Test condition: Pulse wave: (1.2×50)µs
Interval: 10s
Test times: 10,000 times
Test potential should not exceed pulse voltage
as shown in Table−1.
Within ±(1%+0.05Ω)
No evidence of appearance
damage.
7 Terminal strength
Pulling test
Paragraph 6.1.2(1)
Pull force: 25N
Duration: 10s.
8 Terminal strength
Bending test
Paragraph 6.1.2(4)
Test condition: Angle of 90degrees for 5 times.
No evidence of mechanical damage.
9 Resistance to soldering heat Paragraph 6.4
Depth of immersion: A point within 4±0.8mm
from the resistor body.
Temp. of solder bath: 350±10°C
Immersion time: 3.5±0.5s
After immerse into solder, leaving at the room
temp. for 1h, and then measure the resistance.
Within ±(1%+0.05Ω)
No evidence of appearance
damage.