OPTOELECTRONICS LOW CURRENT T-100 & T-134 SOLID STATE LAMPS HIGH EFFICIENCY RED HLMP-1700 HLMP-4700 2mA YELLOW HLMP-1719 HLMP-4719 HIGH EFFICIENCY GREEN HLMP-1790 HLMP-4740 (MV2454) 3.15+0.2 3.020.2 a 4540.3 >] >| (reas le +02) 00.5 26.4 MIN. ler MIN. 2 (ANODE) IE ST4020 2.54 F a we ~j 23 400 (4.87) 0 (2.84) | (5.84), 1 \ | {FLAT ENOTES CATHODE 350 (8.89) Vf 339 (4.38) | ~ / - ' f 1 / _ 017 10.43) 54 040 029 {C.58) {1.02} 050 | 1,00 (25.4) MIN (127) | AEF , | NOTES, 1. ALL DIMENSIONS ARE IN INCHES (mm) : 2, TOLERANCES ARE ~.010 INCH UNLESS | t SPEG.FIED _ 3. AN EPOXY MENISCUS MAY EXTEND ABOUT f 040" {1 mm) DOWN THE LEADS 7 D0 (1.27) al le 100 (2.54) C1062F The T-134 HLMP-4700 Series and T-1 HLMP-1700 Series are direct pin-for-pin replacements for the Hewlett- Packard lamps with the same part numbers. All devices are tinted diffused with a medium-wide viewing angle. The design of the LED chips is optimized for low current applications and is far superior in Luminous Intensity compared to standard LED lamps at very low current. These low current lamps are primarily intended for direct view. m@ Very low power 4mW m 2mA drive from low power TTL or CMOS All three colors Power savings in portable equipment Sturdier leads for easy assembly Both T-1% and T-1 Use MP&2 panel mounting grommet with HLMP-4700, HLMP-4719 and MV2454 m@ Portable battery driven digital or linear electronic equipment like test instruments, robots and toys @ Multiple lamp applications to reduce power drain by 5 to 10 times and decrease power supply size and cost as in phones, PBX and signs SOURCE LENS SIZE TYPE COLOR EFFECT T-1 HLMP-1700 High Efficiency Red Red Diffused HLMP-1719 Yellow Yellow Diffused HLMP-1790 High Efficiency Green Green Diffused T-1% HLMP-4700 High Efficiency Red Red Diffused HLMP-4719 Yellow Yellow Diffused HLMP-4740 (MV2454) High Efficiency Green Green Diffuseda LOW CURRENT T-100 & T-134 OPTOELECTRONICS SOLID STATE LAMPS HI. EFF HILEFF. Hl. EFF HI. EFF. RED YELLOW GREEN RED YELLOW GREEN HLMP- HLMP- HLMP- HLMP- HLMP- HLMP- TEST PARAMETER SYMBOL 4700 4719 4740 1700 1719 1790 UNITS COND. (MV2454) Luminous Intensity min. \ 1.2 1.2 1.2 1.0 1.0 1.0 med r=2mA typ. 2.0 2.0 3.0 2.0 2.0 2 med =2mA Forward voltage max. Vv. 2.2 2.7 2.7 2.2 2.7 27 v =2mA typ. 1.8 1.9 1.9 1.8 1.9 1.9 v =2mA Peak wavelength typ. Ap 635 585 565 635 585 565 nm =2mA Reverse breakdown min. Vor 5 5 5 5 5 5 v p= 100 BA voltage Viewing angle typ. 201% 35 35 35 50 50 50 degrees (total) PARAMETER Power dissipation 27 24 27 mw 1 DC forward current 75 75 7.5 mA Peak forward current (PW<1 ms, DF =< 30%) 25 20 25 mA Lead soldering time at 260C 5 5 5 sec 2 Operating and storage temperatures 55C to + 100C 1. Derate linearly from 92C at 1 mA/C. 2. At 1/16 inch (1.6 mm) from bottom of lamp.