Vertical Male Connectors Type F For Backplanes 88 signal contacts 25 mm extension module ERmet 2.0mm The ERmet type F vertical male connector provides 88 signal contacts and 22 ground shield contacts in a 8+2 row x 11, fully loaded configuration. With 15 different standard pin lengths to choose from, this is one of the most versatile connectors available. The connector is designed for gas tight pressfit installation. The ERmet type F vertical male connector incorporates pre-alignment guides but has no multifunction cavity. This connector is designed to be used alone. The type F connector can also be used in conjunction with either a type D, E, or DE ERmet connector, however, it can only be installed at the lower end of a connector row. Dimensional drawings and board hole pattern 13.45 0.1 32 10 x 2 = 20 compliant zone for thru hole 0.60.00.0 11 9x2= 18 1 z a b c d e f g h y 3.7 1 max 25 max Board hole pattern (Component mounting side) 10 x 2 = 0.05 all holes ( 20 ) 2 2 + 0.05 not plated thru 3 0.6 + 0.05 - plated thru drill hole 0.7 ( 18 ) 11 08/06 0.02 z a b c d e f g h y 2 9x2= Note: The numbering on the connectors themselves is in accordance with the IEC 61076-4-101 standard. All dimensions in mm. Catalog E 074482 2 - 0.1 21.4 date Id.-Nr. class 1 Edition 4 www.erni.com 155 Vertical Male Connectors Type F For Backplanes Ordering Information Configuration Used For No. of Pins Part Number Type F With Peg 11 10 9 8 7 6 5 4 3 2 1 z a b c d e f g h y 88 104519 110 104154 110 933006 Type F With Peg 11 10 9 8 7 6 5 4 3 2 1 z a b c d e f g h y Type F With Peg And Extended Terminals Bestueckungsplan 11 10 9 8 7 6 5 4 3 2 1 z a b c d e f g h y Contact versions ERNI can accommodate any pattern of male connector contact loading. For shield rows z and f (7 row connectors) or z and y (10 row connectors), level 3 contacts should be specified. For rear I/O and shrouds, choose contacts with the R1, R2 or R3 terminal length. Each contact has a unique letter designation. Use this letter designation when filling in the contact loading requirements on the ERNI Customer Request Form. 156 Catalog E 074482 08/06 Edition 4 www.erni.com