SJ3526N-BLACK-5/8\"X50YD - 3M - Datasheet.Directory

Memory Module Specications

KVR1066D3S8R7SK3/3GI

3GB (1GB 128M x 72-Bit x 3 pcs.) PC3-8500

CL7 Registered w/Parity 240-Pin DIMM Kit

Kingston.com Document No. VALUERAM0781-001.A00 05/09/09 Page 1

DESCRIPTION

ValueRAM’s KVR1066D3S8R7SK3/3GI is a kit of three 128M x

72-bit 1GB (1024MB) DDR3-1066 CL7 SDRAM (Synchronous

DRAM) registered w/parity, single-rank, Intel® Compatibility

Tested, memory modules, based on nine 128M x 8-bit DDR3-

1066 FBGA components per module. Total kit capacity is 3GB

(3072MB). Each SPD is programmed to JEDEC standard

latency 1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM

uses gold contact ngers and requires +1.5V. The electrical and

mechanical specications are as follows:

FEATURES

• JEDEC standard 1.5V ± 0.075V Power Supply

• VDDQ = 1.5V ± 0.075V

• 533MHz fCK for 1066Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 6,7,8,9,10

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• Programmable CAS Write Latency(CWL) = 6(DDR3-1066)

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does

not allow seamless read or write [either on the y using A12

or MRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• On-DIMM thermal sensor (Grade B)

• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE ≤ 95°C

• Asynchronous Reset

• PCB : Height 1.180” (30.00mm), double sided component

SPECIFICATIONS

CL(IDD) 7 cycles

Row Cycle Time (tRCmin) 50.625ns (min.)

Refresh to Active/Refresh 110ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin) 37.5ns (min.)

Power 2.452 W (operating per module)

UL Rating 94 V - 0

Operating Temperature 0° C to 85° C

Storage Temperature -55° C to +100° C

Continued >>