MEMBRAPOR SPECIFICATION SHEET FOR CO SENSOR TYPE CO/MF-500 PERFORMANCE CHARACTERISTICS PHYSICAL CHARACTERISTICS Nominal Range Maximum Overload Expected Operation Life Output Signal Inboard Filter Weight Position Sensitivity Storage Life Resolution Temperature Range Pressure Range Pressure Coefficient t90 Response Time Relative Humidity Range Typical Baseline Range (pure air, 20C) Maximum Zero Shift (+20C to +40 C) Expected Long Term Output Drift Recommended Load Resistor Bias Voltage Repeatability Output Linearity 0 - 500 ppm 2000 ppm 2 years in air 70 20 nA/ppm To remove H2S and SO2 1 ppm - 20 C to + 50 C Atmospheric 10 % No data < 25 sec 15 % to 90 % R.H. non-condensing - 2 ppm to +3 ppm 9 ppm equivalent < 2 % signal loss/month 10 Ohm Not required < 2 % of signal Linear CROSS-SENSITIVITY DATA Interfering Gas Concentration H2 H2S 100 ppm 10 ppm ~ 5.4 g None Six months in container 5 C - 20 C Recommended Storage Temperature Warranty Period 12 months from date of dispatch Miniature-Size Outline Dimensions BOTTOM VIEW Reference Sensing Counter 90 18 mm SIDE VIEW 13.5 mm PCD 20 mm Reading < 40 ppm ~ 0 ppm 5 mm Pin Projection 1.5 mm Pins on 13.5 mm PCD Performance data conditions: 20 C, 50% RH and 1013 mbar APPLICATIONS Safety and Environmental Control For Portable Gas Detectors REV.: 2/2008 Phone: +41 43 311 72 00 Fax : +41 43 311 72 01 Email: info@membrapor.ch www.membrapor.ch Page 1 of 2 MEMBRAPOR AG Rautistrasse 164 CH-8048 Zurich Switzerland MEMBRAPOR SPECIFICATION SHEET FOR CO SENSOR TYPE CO/MF-500 TEMPERATURE DEPENDENCE The output of an electrochemical sensor varies with temperature. The graphs below show the variation in output with temperature for this type of sensor. The results are shown in the graphs as a mean for a batch of sensors, along with confidence intervals corresponding to 3 times the standard deviation. The sensitivity dependence is expressed as a percentage of the signal at 20 C. Sensitivity Temperature Dependence 120% Output (referenced to 20 C) 110% 100% 90% 80% 70% Mean 60% +3SD -3SD 50% -20 -10 0 10 20 30 40 50 Tem perature (C) The data contained in this document is for guidance only. Membrapor AG accepts no liability for any consequential losses, injury or damage resulting from the use of this document or the information contained within it. The data is given for guidance only. Customers should test under their own conditions, to ensure that the sensors are suitable for their own requirements. REV.: 2/2008 Phone: +41 43 311 72 00 Fax : +41 43 311 72 01 Email: info@membrapor.ch www.membrapor.ch Page 2 of 2 MEMBRAPOR AG Rautistrasse 164 CH-8048 Zurich Switzerland