Produktinformation für
Positionierbaugruppe FM353, Best.-Nr. 6ES7353-1AH01-0AE0
Positionierbaugruppe FM354, Best.-Nr. 6ES7354-1AH01-0AE0
Positionierbaugruppe FM453, Best.-Nr. 6ES7453-3AH00-0AE0
Deutsch
Gültigkeitsbereich dieser Produktinformation
Diese Produktinformation ist gültig für die Positionierbaugruppen mit den folgenden Bestellnummern:
Baugruppe Bestellnummer
FM353 6ES7353-1AH01-0AE0
FM354 6ES7354-1AH01-0AE0
FM453 6ES7453-3AH00-0AE0
In diesem Dokument wird ein spezielles Verhalten der Inbetriebnahmemaske des Parametriertools der
Baugruppen beschrieben.
Informationen zu den einzelnen Positionierbaugruppen finden Sie in den jeweiligen Handbüchern zu den
Baugruppen, welche Sie zusätzlich zu dieser Produktinformation benötigen.
Hinweis zur Steuerung von Antrieben über die Inbetriebnahmemaske
Das Parametriertool der jeweiligen Positionierbaugruppe enthält eine Inbetriebnahmemaske die das Testen
und Verfahren von Achsen während der Inbetriebnahme einer Maschine erlaubt. Über diese Inbetrieb-
nahmemaske kann z.B. die Reglerfreigabe gegeben und die Achse dann verfahren werden.
Die Kommunikation des Programmiergerätes oder PCs erfolgt dabei über MPI zur S7-CPU. Tritt bei
laufender Achse ein Kommunikationsproblem auf, dann läuft die Achse weiter und kann vom PG/PC aus
nicht mehr bedient werden !
Erst nach Behebung des Kommunikationsproblems und Wiederherstellung der Verbindung ist ein Stoppen
des Antriebs wieder möglich.
Es muss daher unbedingt vor Verwendung der Funktion sichergestellt werden, dass entsprechende
Maßnahmen getroffen wurden (z.B. Not-Aus-Schalter, Endschalter, Schutzvorrichtungen, Überwachungs-
einstellungen), um eine Gefährdung oder Sach- und Personenschäden auszuschließen.
Sicherheitshinweis
Wenn Achsen über die Inbetriebnahmemaske des Parametriertools gesteuert werden kann eine
Unterbrechung der MPI-Kommunikation zwischen PG/PC und S7-CPU dazu führen, dass die
Achsen weiter drehen, aber ein Eingriff über die Inbetriebnahmemaske nicht mehr möglich ist !
Es ist daher unbedingt sicherzustellen, dass beim Verfahren von Achsen über die Inbetriebnahme-
maske des Parametriertools eine direkte Eingriffs- bzw. Abschaltmöglichkeit besteht.
Es müssen alle erforderlichen Maßnahmen getroffen werden (z.B. Not-Aus-Schalter, Hardware-
endschalter, Schutzvorrichtungen, Überwachungen), um eine Gefährdung oder Sach- und
Personenschäden auszuschließen.
A5E00390472 Version: AA Aug-04