MBRF1090CT thru MBRF10100CT Dual High-Voltage Schottky Barrier Rectifiers Reverse Voltage 90 to 100 Volts Forward Current 10.0 Amperes Features Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Dual rectifier construction, positive center tap Metal silicon junction, majority carrier conduction Low power loss, high efficiency Guardring for overvoltage protection For use in low voltage, high frequency inverters, free wheeling, and polarity protection applications ITO-220AB Mechanical Data Case: JEDEC ITO-220AB molded plastic body Terminals: Plated leads, solderable per MIL-STD-750, Method 2026 High temperature soldering guaranteed: 250oC/10 seconds, 0.25" (6.35mm) from case Polarity: As marked Mounting Position: Any Mounting Torque: 10 in-lbs maximum Weight: 0.08 ounce, 2.24 grams Maximum Ratings and Electrical Characteristics Dimensions in inches and (millimeters) ( TC = 25oC unless otherwise noted ) Symbol MBRF1090CT MBRF10100CT Unit Maximum repetitive peak reverse voltage Parameter VRRM 90 100 Volts Working peak reverse voltage VRWM 90 100 Volts Maximum DC blocking voltage V DC 90 100 Maximum average forward rectified current (See Fig. 1) Total device Per leg Peak forward surge current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) per leg Peak repetitive reverse current per leg at tp = 2.0us, 1KHz Voltage rate of change (rated VR) Volts IF(AV) 10 5.0 Amps IFSM 120 Amps IRRM 0.5 Amps dv/dt 10,000 V/us VF 0.85 Volts Maximum instantaneous forward voltage per leg (Note 4) at IF=5.0A, TC=25oC at IF=5.0A, TC=125oC Maximum reverse current per leg at working peak reverse voltage (Note 4) TJ=25oC TJ=100oC Typical thermal resistance per leg RMS Isolation voltage (MBRF type only) from terminals to heatsink with t = 1.0 second, RH < 30% Operating junction temperature range Storage temperature range Notes: 0.75 100 uA 6.0 mA IR o RJC 6.8 VISOL 4500 (Note 1) 3500 (Note 2) 1500 (Note 3) TJ -55 to +150 o C TSTG -55 to +150 o C 1. Clip mounting (on case), where lead does not overlap heatsink with 0.110" offset 2. Clip mounting (on case), where leads do overlap heatsink 3. Screw mounting with 4-40 screw, where washer diameter is < 4.9 mm (0.19") 4. Pulse test: 300us pulse width, 1% duty cycle 358 C/W Volts RATINGS AND CHARACTERISTIC CURVES ( TA = 25oC unless otherwise noted ) 359