NSD15-S 15W DC-DC Regulated Single Output series Features : Wide 4:1 DC input range Protections: Short circuit / Overload / Over voltage 1500VDC I/O isolation Built-in EMI filter Cooling by free air convection Output voltage trimming function Built-in remote ON-OFF control 100% full load burn-in test Low cost High reliability 2 years warranty SPECIFICATION MODEL OUTPUT NSD15-12S3 NSD15-12S5 NSD15-12S12 NSD15-12S15 NSD15-48S3 NSD15-48S5 NSD15-48S12 NSD15-48S15 DC VOLTAGE 3.3V 5V 12V 15V 3.3V 5V 12V 15V RATED CURRENT 3.75A 3A 1.25A 1A 3.75A 3A 1.25A 1A CURRENT RANGE 0.18 ~ 3.75A 0.15 ~ 3A 0.06 ~ 1.25A 0.05 ~ 1A 0.18 ~ 3.75A 0.15 ~ 3A 0.06 ~ 1.25A 0.05 ~ 1A RATED POWER 12.375W 15W 15W 15W 12.375W 15W 15W 15W CAPACITIVE LOAD (max.) 3300uF RIPPLE & NOISE (max.) Note.2 100mVp-p(25% ~ 100% load) for 3.3V only 75mVp-p(25% ~ 100% load) VOLTAGE TOLERANCE Note.3 2.0% INPUT LINE REGULATION 1.0% at 10% ~ 100% load LOAD REGULATION 1.0% at 10% ~ 100% load TRIM OUTPUT (Typ.) +10% SETUP TIME RATED DC INPUT VOLTAGE RANGE EFFICIENCY (Typ.) 100ms/RATED DC INPUT at full Load 12VDC 9.4 ~ 36VDC 73% 77% 81% DC CURRENT SHUTDOWN IDLE CURRENT 1.8A/12VDC 20mA 5.0% 5.0% 3.0% +10% 5.0% 5.0% 3.0% 81% 48VDC 18 ~ 72VDC 77% 81% 84% 85% 13.8 ~ 18V 17.25 ~ 22.5V 0.4A/48VDC Above 105% rated output power Protection type : Over power limiting, recovers automatically after fault condition is removed PROTECTION 5.8 ~ 6.93V 5.8 ~ 7.5V 13.8 ~ 18V 17.25 ~ 22.5V 5.61 ~ 6.93V 5.5 ~ 7.5V OVER VOLTAGE(CLAMP) Note.4 Recovers automatically after fault condition is removed SHORT CIRCUIT Logic "1" or open circuit : ON Logic "0" or short to PIN2 : OFF FUNCTION ON/OFF CONTROL -25 ~ +70 WORKING TEMP. OVERLOAD ENVIRONMENT WORKING HUMIDITY 0% ~ 95% RH max. STORAGE TEMP., HUMIDITY -40 ~ +85, 0 ~ 95% RH TEMP. COEFFICIENT SAFETY STANDARDS SAFETY & ISOLATION VOLTAGE ISOLATION RESISTANCE EMC (Note 5) EMC EMISSION EMC IMMUNITY MTBF OTHERS DIMENSION PACKING NOTE 0.03%/ (0~50) UL60950-1 approved, Design refer to TUV EN60950-1 I/P-O/P:1.5KVDC I/P-O/P:100M Ohms / 500VDC / 25/ 70% RH Compliance to EN55022 (CISPR22) Class B Compliance to EN61000-4-2,3,4,6,8; EN55024, light industry level, criteria A 1734K hrs min. MIL-HDBK-217F (25) 50.8*38.1*9.82mm (2"*1.5"*0.387") (L*W*H) 0.03Kg; 180pcs/6.4Kg/0.97CUFT 1. All parameters NOT specially mentioned are measured at 12, 48VDC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Short circuit no more than 60 seconds. 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) 6. Derating to 80% load is needed for NSD15-48S series at 18Vdc input voltage. Full output wattage can be acquired when the input voltage is higher than 20Vdc. 7. EMC filter suggestion: 80uH + Vin - 680uF + + PSU Vo - File Name:NSD15-S-SPEC 2014-12-24 NSD15-S 15W DC-DC Regulated Single Output Mechanical Specification series 5.84[0.23] Unit:mm[inch] 1.8[0.071] 10.8[0.425] 1[0.039] 5.08[0.2] 6 1 +VOUT +VIN 2 10.16[0.4] -VIN 7 -VOUT 4 8 CONTROL 6.35[0.25] TRIM 3.81[0.15] 45.72 [1.8] 10.16[0.4] 10.16[0.4] 38.1[1.5] 9.82[0.387] 13.33[0.525] 50.8[2] 50.8 [2] Pin No. Assignment Pin No. 1 2 3,5 4 Assignment +VIN -VIN No Pin CONTROL Pin No. 6 7 8 Assignment +VOUT -VOUT TRIM Block Diagram fosc : 400KHz POWER SWITCHING EMI FILTER I/P O.L.P. RECTIFIERS & FILTER DETECTION CIRCUIT PWM CONTROL C TRL +VOUT -VOUT TRIM O.V.P. Derating Curve ON/OFF Control & Output Trim 1 +VIN +VOUT -VIN -VOUT 6 100 LOAD 2 80 7 0 ~ 100K 0 ~ 100K 75 4 LOAD (%) 60 8 C TRL TRIM UP DOWN TRIMPOT 40 CONTROL INPUT.....................................PIN4 20 CONTROL COMMON................................PIN2 LOGIC COMPATIBILITY......CMOS OR OPEN COLLECTOR TTL -25 0 10 20 30 40 50 AMBIENT TEMPERATURE () 60 70 (HORIZONTAL) CONTROL VOLTAGE ON............+5.5VDC min OR OPEN CIRCUIT OFF......+2.5VDC max. OR SHORT TO PIN2 File Name:NSD15-S-SPEC 2014-12-24 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Mean Well: NSD15-12S12 NSD15-12S5 NSD15-48S12 NSD15-48S5