CE DB3/DC34/DB4/DB6
CHENYI ELECTRONICS SILICON BIDIRECTIONAL DIAC
FEATURES
The three layer,two terminal, axial lead, hermetically sealed diacs are
designed specifically for triggering thyristors. They demonstrate low breakover
current at breakover voltage as they withstand peak pulse current,The breakover
symmetry is within three volts(DB3,DC34,DB4)or four volts(DB6).These diacs are
intended for use in thyrisitors phase control, circuits for lamp dimming,universal
motor speed control, and heat control.
JF's DB3/DC34/DB4/DB6 are bi-directional trigged diode designed to operate
in conjunction with Triacs and SCR's
ABSOLUTE RATINGS(LIMITING VALUES)
DB3 DC34 DB4 DB6
Power Dissipation on Printed
Circuit(L=10mm)
Repetitive Peak in-state tp=10u s
Current F=100Hz
TSTG/TJStorage and Operating Junction Temperature
ELECTRCAL CHARACTERISTICS
DB3 DC34 DB4 DB6
c=22nF(Note 2) Min 28 30 35 56
See diagram1 Typ 32 34 40 60
Max 36 38 45 70
|+VBO|- c=22nF(Note 2)
|-VBO| See diagram1
I=(IBO to IF=10mA)
See diagram1
Vo See diagram2 Min V
IBO c=22nF(Note 2) Max A
tr See Diagram 3 Typ S
VB=0.5 VBO max
see diagram 1
Notes: 1. Electrical characteristics applicable in both forward and reverse directions.
2. Connected in parallel with the devices.
ParametersSymbols Units
2.0 2.0 1.6
Value
Symbols Parameters
-40 to +125/-40 to 110
mW
A
Pc
ITRM
TA=50 150
2.0
VBO Breakover Voltage(Note 2)
Output Voltage(Note 1)
Breakover Current(Note 1)
Max
| V|
IB Leakage Current(Note 1)
Rise Time(Note 1)
Value
Dynamic Breakover
Voltage(Note 1)
Breakover Voltage Symmetry
Units
3 4
5
Test Conditions
Max
Min
10
10
V
V
V
A
5
100
1.5
Copyright @ 2000 SHANGHAI CHENYI ELECTRONICS CO.,LTD Page 1 of 2
CE DB3/DC34/DB4/DB6
CHENYI ELECTRONICS SILICON BIDIRECTIONAL DIAC
RATINGS AND CHARACTERISTIC CURVES DB3/DC34/DB4/DB6
DIAGRAM 1: Current-voltage charateristics DIAGRAM 2: Test circuit for output voltage
DIAGRAM 3: Test circuit see diagram2 adjust R for
Ip=0.5A
FIG.1-Power disspation versus ambient
temperature(maximum values) FIG.2-Relative variation of VBO versus juntion
temperature(typical values)
FIG.3-Peak pulse current versus pulse duration
(maximum values)
Copyright @ 2000 SHANGHAI CHENYI ELECTRONICS CO.,LTD Page 2 of 2
