Document 659 Flyback Transformer For ON Semiconductor NCP5080 Photoflash Capacitor Charger * Miniature capacitor charging transformer - 4.6 mm high; 6.2 x 6.8 mm footprint * 2.7 - 5.5 Volts input; 350 V output * 1000 Vrms isolation from the primary to the secondary Core material Ferrite Terminations RoHS tin-silver over copper. Other terminations available at additional cost. Weight 0.30 g Ambient temperature -40C to +125C Storage temperature Component: -40C to +125C. Packaging: -40C to +80C Resistance to soldering heat Max three 40 second reflows at +260C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) 38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332 Packaging 250/7 reel; 1000/13 reel Plastic tape: 16 mm wide, 0.35 mm thick, 12 mm pocket spacing, 5.0 mm pocket depth PCB washing Only pure water or alcohol recommended Part number1 CJ5143-AL_ Inductance at 0 A2 10% (H) 15.0 Inductance at Ipk3 min (H) 13.5 Leakage inductance4 max (H) 0.3 DCR max (Ohms) pri sec 1.0 25 1. When ordering, please specify termination and packaging codes: CJ5143-ALC Termination: L = RoHS compliant tin-silver (96.5/3.5) over copper. Special order, added cost: T = RoHS tin-silver-copper (95.5/4/0.5) over copper or S = non-RoHS tin-lead (63/37) over copper. Packaging: C = 7 machine-ready reel. EIA-481 embossed plastic tape (250 parts per full reel). B = Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter C instead. D = 13 machine-ready reel. EIA-481 embossed plastic tape. Factory order only, not stocked (1000 parts per full reel). 2. Inductance measured at 100 kHz, 0.1 Vrms. 3. Peak primary current drawn at minimum input voltage. 4. Leakage inductance is for the primary winding with the secondary winding shorted. 5. Electrical specifications at 25C. Refer to Doc 362 "Soldering Surface Mount Components" before soldering. Dot indicates pin 1 0.194 max 4,60 0.004 /0,10 0.268 max 6,80 1 0.055 1,40 6 0.079 2.00 5 4 0.193 4,90 0.039 1,00 4 Pri 4 6 5 0.079 2,00 Sec 5 0.028 0,70 6 1 Recommended Land Pattern Specifications subject to change without notice. Please check our website for latest information. (c) Coilcraft, Inc. 2009 0.244 max 6,20 0.193 4,90 0.055 1,40 1 Ipk3 (A) 1.2 Pri : sec turns ratio 1 : 15 0.023 x 0.031 (6) 0,6 x 0,8 Dimensions are in Document 659 inches mm Revised 02/12/09