3.2x1.6mm SMD CHIP LED LAMP AP3216HC BRIGHT RED Features Description !3.2mmx1.6mm SMT LED, 1.1mm THICKNESS. The Bright Red source color devices are made with !LOW Gallium Phosphide Red Light Emitting Diode. POWER CONSUMPTION. ! WIDE VIEWING ANGLE. !IDEAL FOR BACKLIGHT AND INDICATOR. ! VARIOUS COLORS AND LENS TYPES AVAILABLE. !PACKAGE : 2000PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.2(0.0079") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: DSAB2333 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE: MAY/09/2002 DRAWN: D.L.HUANG PAGE: 1 OF 4 Selection Guide Par t No . Dic e AP3216HC Iv (m c d ) @ 20 m A L en s Ty p e BRIGHT RED(GaP) WATER CLEAR V i ew i n g An g l e Min . Ty p . 21/2 0.8 1.2 12 0 Note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at T)=25C Sy m b o l Par am et er peak Peak Wavelength Bright Red D Dominate Wavelength Bright Red 1/2 D ev i c e Spectral Line Half-width Bright Red Ty p . Un it s Tes t Co n d it io n s 700 nm I F =20mA 660 nm I F =20mA 45 nm I F =20mA pF VF=0V;f=1MHz 2.5 V I F =20mA 10 uA V R = 5V C Capacitance Bright Red 40 VF Forward Voltage Bright Red 2.25 IR Reverse Current Bright Red Max . Absolute Maximum Ratings at T)=25C P ar am e t e r B r i g h t R ed Un it s Power dissipation 120 mW DC Forward Current 25 mA Peak Forward Current [1] 130 mA Reverse Voltage 5 V Operating/Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAB2333 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE: MAY/09/2002 DRAWN: D.L.HUANG PAGE: 2 OF 4 Bright Red AP3216HC SPEC NO: DSAB2333 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE: MAY/09/2002 DRAWN: D.L.HUANG PAGE: 3 OF 4 AP3216HC SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process." Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAB2333 APPROVED: J.LU REV NO: V.1 CHECKED: Allen Liu DATE: MAY/09/2002 DRAWN: D.L.HUANG PAGE: 4 OF 4