©2015 Fairchild Semiconductor Corporation 8www.fairchildsemi.com
FNA23060 Rev. 1.0
FNA23060 600 V Motion SPM® 2 Series
Bootstrap Diode Part
Control Part
Notes:
7. Short-circuit current protection functions only at the low-sides because the sense current is divided from main current at low-side IGBTs. Inserting the shunt resistor for
monitoring the phase current at NU, NV, NW terminal, the trip level of the short-circuit current is changed.
8. The fault-out pulse width tFOD depends on the capacitance value of CFOD according to the following approximate equation : tFOD = 0.8 x 106 x CFOD [s].
9. TTH is the temperature of thermistor itself. To know case temperature (TC), conduct experiments considering the application.
Symbol Parameter Conditions Min. Typ. Max. Unit
VFForward Voltage IF = 1.0 A, TJ = 25°C - 2.2 - V
trr Reverse-Recovery Time IF = 1.0 A, dIF / dt = 50 A / s, TJ = 25°C - 80 - ns
Symbol Parameter Conditions Min. Typ. Max. Unit
IQCCH Quiescent VCC Supply
Current
VCC(UH,VH,WH) = 15 V,
IN(UH,VH,WH) = 0 VVCC(UH) - COM(H),
VCC(VH) - COM(H),
VCC(WH) - COM(H)
--0.15mA
IQCCL VCC(L) = 15 V, IN(UL,VL, WL) = 0 VV
CC(L) - COM(L) --5.00mA
IPCCH
Operating VCC Supply
Current
VCC(UH,VH,WH) = 15 V, fPWM = 20
kHz, Duty = 50%, Applied to one
PWM Signal Input for High-Side
VCC(UH) - COM(H),
VCC(VH) - COM(H),
VCC(WH) - COM(H)
--0.30mA
IPCCL VCC(L) = 15V, fPWM = 20 kHz, Duty =
50%, Applied to one PWM Signal
Input for Low-Side
VCC(L) - COM(L) --9.00mA
IQBS Quiescent VBS Supply
Current VBS = 15 V, IN(UH, VH, WH) = 0 V VB(U) - VS(U),
VB(V) - VS(V),
VB(W) - VS(W)
--0.30mA
IPBS Operating VBS Supply
Current VCC = VBS = 15 V, fPWM = 20 kHz,
Duty = 50%, Applied to one PWM
Signal Input for High-Side
VB(U) - VS(U),
VB(V) - VS(V),
VB(W) - VS(W)
--6.50mA
VFOH Fault Output Voltage VCC = 15 V, VSC = 0 V, VFO Circuit: 4.7 k to 5 V Pull-u p 4 .5 - - V
VFOL VCC = 15 V, VSC = 1 V, VFO Circuit: 4.7 k to 5 V Pull-u p - - 0.5 V
ISEN Sensing Current of
Each Sense IGBT VCC = 15 V, VIN = 5 V, RSC = 0 No
Connection of Shunt Resistor at
NU,V,W Terminal
IC = 30 A - 19 - mA
VSC(ref) Short Circuit Trip Level VCC = 15 V (Note 7) CSC - COM(L) 0.43 0.50 0.57 V
ISC Short Circuit Current
Level for Trip RSC = 20 (± 1%) No Connection of Shunt Resistor at
NU,V,W Terminal (Note 7) -60- A
UVCCD Supply Circuit Under-
Voltage Protection Detection Level 10.3 - 12.8 V
UVCCR Reset Level 10.8 - 13.3 V
UVBSD Detection Level 9.5 - 12.0 V
UVBSR Reset Level 10.0 - 12.5 V
tFOD Fault-Out Pulse Width CFOD = Open (Note 8) 50 - - s
CFOD = 2.2 nF 1.7 - - ms
VIN(ON) ON Threshold Voltage Applied between IN(UH, VH, WH) - COM(H), IN(UL, VL, WL) -
COM(L)
--2.6V
VIN(OFF) OFF Threshold Voltage 0.8 - - V
RTH Resistance of
Thermistor at TTH = 25°C See Figure 7
(Note 9) -47-k
at TTH = 100°C - 2.9 - k