T7 SEALED TOGGLES SEALED TOGGLE SWITCHES LOW COST TOGGLE FOR WET & DUSTY ENVIRONMENTS These toggle switches are rugged, high performance sealed switches designed for use under severe conditions found in heavy equipment, industrial control, marine and appliance applications. They are totally sealed so the switch can withstand direct water spray and submersion, even during operation. They are designed to meet the international submersion specification level IP68S. OTTO's front panel seal is accomplished with an O-ring under the bat handle. However, now a secondary visible bushing seal is offered as an option. T7 toggles are offered in single and double pole configurations. A choice of models are offered to handle power levels to 16 amps, 0.5HP and low level electronic switching applications. Standard Characteristics/Ratings: These toggles feature positive detent action for safe switching operation. In conjunction with the unique OTTO snap-action switch mechanism, the T7 offers non-teasible contact transfer. ELECTRICAL RATINGS: Load Sea Level @ 28VDC or 115VAC Cycles High contact pressure and superior contact wiping action of the OTTO design makes the T7 an excellent choice for switching loads from logic level up to 16 amps. Resistive 16A 25,000 Resistive 10A 50,000 Inductive 10A 25,000 Motor 0.5HP 25,000 DWV 1050Vrms N/A Low Level 10mA max @ 30mV max DC Resistive for 50,000 cycles Electrical Life: See Rating Chart Mechanical Life: 100,000 cycles Seal: IP68S Mounting hardware provided includes two hex nuts, one lockwasher and one keyway washer. An optional panel gasket is also available, see panel seals located in the hardware section of this catalog. Features: * * * * * * * * * Withstands direct water spray Submersible to IP68S Switches up to 16 amps Withstands extreme shock & vibration Positive detent, non-teasible contact transfer 2 & 3-position, momentary & maintained action Choice of terminal styles UL & CSA recognized RoHS & WEEE compliant Operating Temp Range: -30C to +85C MATERIALS: Case: Thermoplastic Bushing: Anodized aluminum alloy Toggle: Stainless steel Terminals: Brass Contacts: Fine silver/silver cadmium oxide Low Level: Gold flash/silver plate Terminal Hardware: 6-32 screw when applicable T7 recommended Quick Connect terminals: AMP 60253-2 for 12-16 AWG AMP 42100-2 for 14-18 AWG Mounting Hardware: Hex nuts, lockwasher, non-turn washer T7 PART NUMBER CODE T7-X X Circuitry Terminal Contact Style Rating 1. 1 Pole 2. 2 Pole 1. 250 Q.C. 1. Std. 2. Screw 2. Low 3. Solder Level 4. PC Pin (consult factory) X X Circuit Made With Actuator At: Keyway Side A. ON B. ON C. (ON) D. (ON) E. (ON) F. ON G. (ON) H. OFF J. OFF K. ON Center Opposite Keyway None OFF None ON None OFF None ON OFF (ON) OFF ON OFF ON None ON None (ON) OFF (ON) X X Toggle Style Button Color* 1. Bat Handle 2. Lever Lockout (consult factory) 3. Dome Button 4. Rocker Button 5. Bat Handle With Bushing Seal 1. Red 2. Black 3. Orange 4. Yellow 5. Green 6. Blue 7. Purple 8. Gray 9. White NOTE: ( ) denotes momentary action. * Only applicable to Toggle Styles 3 & 4; otherwise omit. T7 Connector P/N C801765 134 OTTO Full Line Catalog Specifications Subject To Change Without Notice