Product Specification
PE42359
Page 3 of 14
Document No. DOC-13214-3 │w ww.psemi.com ©2012-2013 Peregrine Semiconductor Corp. All rights reserved.
0
5
10
15
20
25
30
35
40
0 500 1000 1500 2000 2500 3000
InputPower[dBm]
Frequency[MHz]
(VDD=+3.3V)
T=+25C
T=+105C
Table 2. Pin Descriptions
Electrostatic Discharge (ESD) Precautions
When handling this UltraCMOS® device, observe
the same precautions that you would use with
other ESD-sensitive devices. Although this device
contains circuitry to protect it from damage due to
ESD, precautions should be taken to avoid
exceeding the specified rating.
Figure 3. Pin Configuration (Top View)
Pin No. Pin Name Description
1 RF11 RF Port1
2 GND
Ground connection. Traces should be
physically short and connected to ground
plane for best performance.
3 RF21 RF Port2
4 CTRL Switch control input, CMOS logic level.
5 RFC1 RF Common
6 CTRL or VDD
This pin supports two interface options:
Single-pin control mode. A nominal 3-volt
supply connection is required.
Complementary-pin control mode. A com-
plementary CMOS control signal to CTRL
is supplied to this pin. Bypassing on this
pin is not required in this mode.
Table 4. Absolute Maximum Ratings
Symbol Parameter/Conditions Min Max Units
VDD Power supply voltage -0.3 4.0 V
VI Voltage on any DC input -0.3 VDD+
0.3 V
TST Storage temperature range -65 150 °C
TOP Operating temperature
range -40 105 °C
PIN1 Input power (50Ω) see
fig. 4
VESD,HBM ESD voltage HBM2, all pins 2000 V
VESD,CDM ESD voltage CDM3, all pins 1000 V
Table 3. Operating Ranges
Parameter Min Typ Max Units
VDD Power Supply Voltage 1.8 3.0 3.3 V
IDD Power Supply Current
(VDD = 2.3 to 5.5V [+25°C only]) 9 20 µA
Control Voltage High 0.7x VDD V
Control Voltage Low 0.3x VDD V
Figure 4. Maximum Power Handling
Exceeding absolute maximum ratings may cause
permanent damage. Operation should be
restricted to the limits in the Operating Ranges
table. Operation between operating range
maximum and absolute maximum for extended
periods may reduce reliability.
Moisture Sensitivity Level
The Moisture Sensitivity Level rating for the
PE42359 in the SC70 package is MSL1.
Note 1: All RF pins must be DC blocked with an external series capacitor or
held at o VDC
Notes: 1. To maintain optimum device performance, do not exceed Max PIN at
desired operating frequency (see Figure 4)
2. Human Body Model (MIL_STD 883 Method 3015)
3. Charged Device Model (JEDEC JESD22-C101)
Logo updated under non-rev change. Peregrine products are protected under one or more of the following U.S. Patents: http://patents.psemi.com