E
!
! " "#$
$ $%&'
($%&' $ $ % % $ # )'
D
*"+ ' )$
+- !!+ +" ./0/1/....
"23 +4"5!+ ./0/6/716 $ $% 8 '
4 # $ " % #
# )
!!!""#
.6 !" "# 4
! $ % &'
Figure 1
6799/.
: ";$<
=
:3# <
" ()*+,-*(,)
This instruction sheet provides termination
procedures for the unshielded 110Connect panel
mount jacks (Category 3 and 5e) with universal wiring
label.
Reasons for reissue of this sheet are provided in
Section 4, REVISION SUMMARY.
." -/0+(*(,)
The jacks accept four pair, twisted–pair cable with 22
to 26 AWG solid conductors and 20 to 26 AWG
stranded conductors. The maximum conductor
insulation diameter is 1.27 mm [.050 in.].
" */+()1*(,)
Strip back only as much cable jacket as necessary to
perform termination. See Figure 2.
!
"
Figure 2
6'0
>?
NOTE:
# $
% &!'
"" ,2
: 4 9<
1. Lay conductors between connector blocks,
aligning cable jacket with rear of jack assembly.
2. Lace brown pair and opposite rear color pair
with appropriate color code slots (use minimum
slack while maintaining twist to within 12.7 mm
[.50 in.] of termination).
( ) * +
,&-& %./#0
D
12 ( *
+
$ - $ 3
3. Use tool to punch wires down into slot and cut
off excess wire. Remove loose wire pieces.
4. Repeat Steps 2 and 3 with blue pair and
opposite front pair.
5. The optional stuffer cap may be used for
termination or it may be added for additional strain
relief.
"." ,2 . 3 1 0 +4
: 4 9<
1. Bend conductors back to right angle to cable
and insert cable between connector blocks.
2. Pull brown pair and opposite rear color pair
through opening on opposite sides. Bend wires
around blocks and align them with appropriate
color code slots (use minimum slack while
maintaining twist).
),*/
i
),*/
i
),*/
i
),*/
i
),*/
i
1*(,)
!
Figure 3
!
" #
$#%
#%$
$&
&$
$&"
&"$
$'
'$
" #
$&
&$
$&"
&"$
$'
'$
$#%
#%$
(
&
"
&
!
" #
&$
$&"
&"$
$'
'$
$#%
#%$
$&
!
" #
&$
$&"
&"$
$#%
#%$
$'
'$
$&
!
Option 1 Option 2
"
& (
&
! "#$%& '( !
)
* ) * + ,
-- - - )
3. Use tool to punch wires down into slot and cut
off excess wire. Remove loose wire pieces.
4. Repeat Steps 2 and 3 with blue pair and
opposite front pair.
5. Press conductors flat against blocks.
!"!#$ "%&
Since the last revision to this document, the following
changes were made:
S
Updated document to corporate requirements.
$#'
i
%'!#$
!
