Product data sheet
Automation technology - sensors and actuators
Product description M8 cable connector, Contacts: 4, 3.5 - 5.0 mm, not shielded, solder, IP67, UL listed
Area M8 series 768
Order number 99 3383 00 04
Illustration Scale drawing Contact arrangement
You can find the component part drawing and assembly instructions on the next page.
Technical data
General values
Connector design cable connector
Connector locking system screw
Termination solder
Wire gauge (mm) 0.25 mm²
Wire gauge (AWG) 24
Cable outlet 3.5 - 5.0 mm
Upper limit temperature 85 °C
Lower limit temperature – 40 °C
Customs tariff number 85369010
Cable data
Approval 1 UL listed
Electrical values
Rated current (40 °C) 4 A
Rated voltage 60 V
Rated impulse voltage 1500 V
Pollution degree 3
Overvoltage category III
Insulating material group III
EMC compliance not shielded
Degree of protection IP67
Mechanical operation > 100 Mating cycles
Material
Contact material CuZn (brass)
Contact plating Au (gold)
Contact body material PA
Housing material PA
Date: 2019-07-28 - Page 1 of 3
Product data sheet
Automation technology - sensors and actuators
Product description M8 cable connector, Contacts: 4, 3.5 - 5.0 mm, not shielded, solder, IP67, UL listed
Area M8 series 768
Order number 99 3383 00 04
Component part drawing
Assembly instructions / Panel cut-out
Date: 2019-07-28 - Page 2 of 3
Product data sheet
Automation technology - sensors and actuators
Product description M8 cable connector, Contacts: 4, 3.5 - 5.0 mm, not shielded, solder, IP67, UL listed
Area M8 series 768
Order number 99 3383 00 04
Security notices
The connectors are designed for use in plant, control system and electrical equipment. The end user is responsible
for checking whether the connectors are suitable for use in other applications.
Connectors with degree of protection IP 67 and IP 68 are not suitable for use under water. When used outdoors, the
connectors must be separately protected against corrosion. For further information about IP degrees of protection
refer to ‘Technical support’ in the Download Centre.
To lock the cable connector to the equipment connector, the threaded ring is tightened until it is ‘finger-tight’
(approx. 50 cNm).
Powered by TCPDF (www.tcpdf.org)
Date: 2019-07-28 - Page 3 of 3
