Embedded Power for Business-Critical Continuity Rev.3.4.09_90 SMT10E_05 Series 1 of 4 SMT10E Series 3.0 - 5.5 Vin Total Power: 13.2 Watts Input Voltage: 3.0 - 5.5 Vdc # of Outputs: Single Electrical Specifications Special Features * 10 A current rating * Input voltage range: 3.0 Vdc to 5.5 Vdc * Output voltage range: 0.8 Vdc to 3.63 Vdc * Ultra high efficiency: 96% @ 5 Vin and 3.3 Vout * Extremely low internal power dissipation * Minimal thermal design concerns * Designed in reliability: MTBF of >7 million hours per Telcordia SR-332 * Ideal solution where board space is at a premium or tighter card pitch is required * Industry standard surface-mount footprint * Available RoHS compliant * 2 year warranty Input Input voltage range: Input current: * UL/cUL CAN/CSA 22.2 No. E186249 * TUV Product Service (EN60950) Certificate No. B 08 05 51485 378 * CB report and certificate to DE3-51686M1 No load 70 mA typ. Input current (max.): 8 A max. @ lo max. and Vout = 3.63 V Input current ripple: 110 mA rms Remote ON/OFF: (See Note 2) Start-up time: 20 ms Output Voltage adjustability: (See Note 1) Fixed output versions Wide trim version 10% 0.8 - 3.63 Vdc Setpoint accuracy: 0.4% Line regulation: 0.2% Load regulation: 1.0% Minimum load: 0A Overshoot/Undershoot: None Ripple and noise: Safety 3.0-5.5 Vdc 0 to 20 mHz BW 50 mV pk-pk 25 mV rms max. Temperature co-efficient: 0.01%/C Transient response: 60 mV max. deviation 50s recovery to within 1.0% Remote sense: 10% Vo compensation All specifications are typical at 5 Vin and 3.3 Vout, full load at 25 C unless otherwise stated. Embedded Power for Business-Critical Continuity Rev.3.4.09_90 SMT10E_05 Series 2 of 4 EMC Characteristics Electrostatic discharge: EN61000-4-2, IEC801-2 Conducted immunity: EN61000-4-6 Radiated immunity: EN61000-4-3 General Specifications Efficiency: See table Insulation voltage: Non-isolated Switching frequency: Fixed 300 kHz typ. Approvals and standards: EN60950 UL/cUL60950 Material flammability: UL94V-0 Dimensions (L x W x H) 33.02 x 13.46 x 8.21 mm 1.3 x 0.53 x 0.323 inches Weight: 6.3 g (0.22 oz) Coplanarity: 100 m MTBF: Telcordia SR-332 MIL-HDBK-217F 7,042,000 hours 680,000 hours Environmental Specifications Thermal performance: (See Note 3) Operating ambient temperature -40 C to +100 C Non-operating -40 C to +125 C Protection Short circuit: Continuous Thermal: Automatic recovery Embedded Power for Business-Critical Continuity Rev.3.4.09_90 SMT10E_05 Series 3 of 4 Ordering Information All specifications are typical at 5 Vin and 3.3 Vout, full load at 25 C unless otherwise stated. Ordering Information Output Power (Max.) Input Voltage Output Voltage 13.2 W 3.0 - 5.5 Vdc 16.5 W 3.0 - 5.5 Vdc 19.8 W Output Currents Regulation Min Max Efficiency (typ.) Line Load 1.2 Vdc 0A 10 A 89% 0.2% 1.0% SMT10E-05S1V2J (EOL) 1.5 Vdc 0A 10 A 90% 0.2% 1.0% SMT10E-05S1V5J (EOL) 3.0 - 5.5 Vdc 1.8 Vdc 0A 10 A 92% 0.2% 1.0% SMT10E-05S1V8J (EOL) 27.5 W 3.0 - 5.5 Vdc 2.5 Vdc 0A 10 A 95% 0.2% 1.0% SMT10E-05S2V5J (EOL) 36.3 W 4.5 - 5.5 Vdc 3.3 Vdc 0A 10 A 96% 0.2% 1.0% SMT10E-05S3V3J (EOL) 36.3 W 3.0 - 5.5 Vdc 0.8 - 3.63 Vdc 0A 10 A 96% 0.2% 1.0% SMT10E-05W3V3J Part Number System with Options Model Numbers (2, 4, 5) SMT10E-05S3V3J Product Family SMT = Surface-mount Packaging Options (4) J = Pb-free (RoHS 6/6 compliant) Rated Output Current 10 = 10 Amps Output Voltage 1V2 = 1.2 V, 1V5 = 1.5 V, 1V8 = 1.8 V, 2V5 = 2.5 V, 3V3 = 3.3 V Performance E = Enhanced Performance Type of Output S = Single W = Wide Input Voltage 05 = 3.0 Vdc to 5.5 Vdc Output Voltage Adjustment of the SMT10E-05W3V3J Series The ultra-wide output voltage trim range offers major advantages to users who select the SMT10E-05W3V3J. It is no longer necessary to purchase a variety of modules in order to cover different output voltages. The output voltage can be trimmed in a range of 0.8 Vdc to 3.63 Vdc. When the SMT10E-05W3V3J converter leaves the factory the output has been adjusted to the default voltage of 3.3V. * When Vin 4.5 V, then Vout can be adjusted from 0.8 Vdc to 3.6 Vdc * When Vin < 4.5 V, then Vout can be adjusted from 0.8 Vdc to 2.75 Vdc Notes Notes Continued 1 3 2 When Vin 4.5 V, then Vout can be adjusted from 0.8 Vdc to 3.6 Vdc. When Vin < 4.5 V, then Vout can be adjusted from 0.8 Vdc to 2.75 Vdc. The SMT10E features a `Negative Logic' Remote ON/OFF operation. If not using the Remote ON/OFF pin, leave the pin open (the converter will be on). The Remote ON/OFF pin is referenced to ground. The following conditions apply for the SMT10E: Configuration Operation Remote pin open circuit Remote pin pulled low Remote pin pulled high [Von/off >1.2 V] Converter Unit is ON Unit is ON Unit is OFF A `Positive Logic' Remote ON/OFF version is also possible with this converter. To order please place the suffix `-R' at the end of the model number, e.g. SMT10E-05W3V3-RJ. 4 5 Full derating curves available in both the Longform Datasheet and Application Note 168. TSE RoHS 5/6 (non Pb-free) compliant versions may be available on special request, please contact your local sales representative for details. NOTICE: Some models do not support all options. Please contact your local Emerson Network Power representative or use the on-line model number search tool at http://www.PowerConversion.com to find a suitable alternative. Embedded Power for Business-Critical Continuity Americas Mechanical Drawing Rev.3.4.09_90 SMT10E_05 Series 4 of 4 5810 Van Allen Way Carlsbad, CA 92008 USA Telephone: +1 760 930 4600 Facsimile: +1 760 930 0698 TOP VIEW 0.039 (1.00) Europe (UK) 0.530 0.010 (13.46 0.25) 0.039 (1.00) Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom Telephone: +44 (0) 1384 842 211 Facsimile: +44 (0) 1384 843 355 BOTTOM VIEW 4 3 2 1 6 SIDE VIEW 0.048 (1.22) 0.323 (8.21) Installed Ht. 0.007 (0.18) Min Clearance Asia (HK) 0.405 (10.29) 0.430 (10.92) 5 0.297 (7.54) 0.075 (1.91) 0.310 (7.87) 1.3000.010 (33.02 0.25) 0.190 (4.83) 0.190 (4.83) 0.190 (4.83) For global contact, visit: www.PowerConversion.com techsupport.embeddedpower @emerson.com Seating Plane Max. component Connector (6PL) Width: 0.112 0.003 (2.84 0.08) Length: 0.062 0.002 (1.57 0.04) 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon Hong Kong Telephone: +852 2176 3333 Facsimile: +852 2176 3888 All dimensions in inches (mm) All tolerance 0.010in (0.25 mm) unless otherwise stated While every precaution has been taken to ensure accuracy and completeness in this literature, Emerson Network Power assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. Emerson Network Power. The global leader in enabling business-critical continuity. AC Power Pin Connections Connectivity Pin Number Function Pin 1 Remote ON/OFF Embedded Computing Pin 2 Remote Sense + Embedded Power Pin 3 Trim Pin 4 +Vout Pin 5 Ground Power Switching & Controls Pin 6 +Vin Precision Cooling Racks & Integrated Cabinets DC Power Monitoring Outside Plant Services Surge Protection EmersonNetworkPower.com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. (c)2008 Emerson Electric Co.