Fine Adjust Applicator for Micro-Fit 3.0 Crimp Terminals
Doc No: ATS-639004500 Release Date: 08-17-07
UNCONTROLLED COPY
Page 5 of 5
Revision: H Revision Date: 07-06-17
NOTES
1. Molex recommends that an extra perishable tooling kit be maintained at your facility.
2. Verify tooling alignment by manually cycling the press and applicator before crimping under power. Check that
all screws are tight.
3. Slugs, terminals, dirt and oil should be kept clear of the work area.
4. Wear safety glasses at all times.
5. For recommended maintenance, refer to the FineAdjust manual.
CAUTION: This applicator should only be used in a press with a shut height of 135.8mm (5.346”). Tooling
damage could result at a lower setting.
CAUTION: To prevent injury never operate this Applicator without the guards supplied with the press or wire-
processing machine in place. Reference the press or wire processing manufacturer’s instruction manual.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals, applicators and tooling.
CAUTION
Molex tooling crimp specifications are valid only when used with Molex terminals and tooling
manufactured by Molex and sold by Molex or authorized distributors (“Molex Tooling”).
When using tooling other than Molex Tooling with Molex-specific connector systems listed in
the ATS documents, the Molex Tooling qualification does not apply, and the responsibility for
full qualification of the connector system is that of the customer.
Molex accepts no liability for connector performance or tooling support where tooling other than
Molex Tooling is used or where Molex Tooling is modified.
CAUTION
A-620 and other industry standards do not supersede the manufacturer’s specifications.
Some terminals designed over 20 years ago may not meet the desired physical attributes for
some of today’s standards; however, these terminals will still perform electrically at an
acceptable quality level based on qualification testing and years of successful performance in
the field.
Application Tooling Support
Phone: (402) 458-TOOL (8665)
E-Mail: applicationtooling@molex.com
Website: www.molex.com/applicationtooling
Molex is a registered trademark of Molex, LLC in the United States of America and may be registered in other countries; all other trademarks
listed herein belong to their respective owners.