CN1J2
CN1J4
CN1J8
1/16W (.063W) 50V
±200:
R≥10Ω
±400:
R<10Ω
10 - 1M
81
KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: 814-362-8883 • www.koaspeer.com
Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. 11/14/17
CN
concave termination with square corners
resistor array
Absolute
Maximum
Working
Voltage
E-24
(J:±5%)
Resistance Range (Ω)
Part
Designation
Maximum
Overload
Voltage
(5 Secs. Max.)
Rated
Terminal
Part
Temp.
Power Rating
@ 70°C
(Per Element)
T.C.R. (ppm/°C) Max.
applications and ratings
circuit schematic
1/10W (.100W)
1/8W (.125W)
100V
100V
200V
200V 400V
+125°C
Rated
Ambient
Temp.
+70°C
Performance Characteristics
E-24
(G:±2%)
E-24, E-96
(F:±1%)
J:±5%,
G:±2%
F:±1%
CN2A2
CN2A4
CN2A8
CN2B2
CN2B4
CN2B8
10 - 1M
–––
–––
10 - 1M
10 - 1M
Parameter
Requirement ∆ R ±%
Limit Typical Test Method
Resistance
T.C.R.
25°C
+25°C/-55°C, +25°C/+125°C
Within specified
tolerance
Within specified
T.C.R.
—
—
Overload (Short time) Rated voltage x 2.5 for 5 seconds
±2.0% ±0.5%
Resistance to Solder Heat 260°C ± 5°C, 10 seconds ± 1 second
±1.0% ±0.25%
Rapid Change of Temperature -55°C (30 minutes), +125°C (30 minutes), 5 cycles
±1.0% ±0.5%
Moisture Resistance 40°C ± 2°C, 90 - 95% RH, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle
±5.0% ±1.0%
Endurance at 70°C 70°C ± 2°C, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle
±5.0% ±0.5%
High Temperature Exposure
CN1E2, CN1E4: +125°C, 1000 hours
±1.0%
±0.2%: CN1E2,
CN1E4
CN1J2, CN1J4J, CN1J8, CN2A2, CN2A4, CN2A8, CN2B2, CN2B4, CN2B8:
+155°C, 1000 hours
±0.3%: Other
10 - 1M
1 - 1M
CN1E2
CN1E4 1/16W (.063W) 25V
––– –––
±100:
R≥10Ω
±200:
R≥10Ω
–––
–––
±200:
R≥10Ω
–––––– 50V10 - 100k
10 - 1M
resistors
* Note that network resistors generate higher heat rather than single flat chip resistor under rated power output.
Operating Temperature Range: -55°C to +125°C (CN1E), -55°C to +155°C
If any questions should arise whether to use the “Rated Ambient Temperature” or the “Rated Terminal Part Temperature,” please give priority
to the “Rated Terminal Part Temperature.” Prior to use and for more details refer to “Introduction of the derating curves on the terminal part
temperature” in the beginning of the catalog.
For resistors operated at an ambient temperature of 70°C or above, a
power rating shall be derated in accordance with the above derating curve.