SPEC NO: DSAG0965 REV NO: V.3 DATE: JUN/25/2007 PAGE: 1 OF 4
APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Y.L.LI
SURFACE MOUNT DISPLAY
Part Number: KCSA02-105 Hyper Red
Features
z 0.2INCH DIGIT HEIGHT.
z LOW CURRENT OPERATION.
z EXCELLENT CHARACTER APPEARANCE.
z I.C. COMPATIBLE
z MECHANICALLY RUGGED.
z GRAY FACE,WHITE SEGMENT.
z PACKAGE : 650PCS / REEL.
z MOISTURE SENSITIVITY LEVEL : LEVEL 4.
z RoHS COMPLIANT.
Description
The Hyper Red source color devices are made with In-
GaAlP on GaAs substrate Light Emitting Diode.
Package Dimensions& Intern al Circuit Diagram
Notes:
1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.
2. Specifications are subject to change without notice.
3. The gap between the reflector and PCB shall not exceed 0.25mm.
SPEC NO: DSAG0965 REV NO: V.3 DATE: JUN/25/2007 PAGE: 2 OF 4
APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Y.L.LI
Selection Guide
Note:
1. Luminous intensity/ luminous Flux: +/-15%.
Absolute Maximum Ratings at TA=25°C
Electrical / Optical Characteristics at TA=25°C
Notes:
1.Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
Part No. Dice Lens Type
Iv (ucd) [1]
@ 10mA
Min. Typ.
KCSA02-105 Hyper Red (InGaAlP) WHITE DIFFUSED 8000 30400 Common Anode, Rt.
Hand Decimal.
Description
Symbol Parameter Device Typ. Max. Units Test Conditions
λpeak Peak Wavelength Hyper Red 650 nm IF=20mA
λD [1] Dominant Wavelength Hyper Red 635 nm IF=20mA
Δλ1/2 Spectral Line Half-width Hyper Red 28 nm IF=20mA
C Capacitance Hyper Red 35 pF VF=0V;f=1MHz
VF [2] Forward Voltage Hyper Red 1.95 2.5 V IF=20mA
IR Reverse Current Hyper Red 10 uA VR=5V
Parameter Hyper Red Units
Power dissipation 75 mW
DC Forward Current 30 mA
Peak Forward Current [1] 185 mA
Reverse Voltage 5 V
Operating / Storage Temperature -40°C To +85°C
SPEC NO: DSAG0965 REV NO: V.3 DATE: JUN/25/2007 PAGE: 3 OF 4
APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Y.L.LI
Hyper Red KCSA02-105
SPEC NO: DSAG0965 REV NO: V.3 DATE: JUN/25/2007 PAGE: 4 OF 4
APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Y.L.LI
KCSA02-105
Recommended Soldering Pattern
(Units : mm; Tolerance: ± 0.15)
Tape Specifications
(Units : mm)
