Silicon 1N3899-3903, Diodes Features: _ e Fast Recovery Time200 Nanoseconds Maximum O e@ Recovery Characteristics match the High Frequency capability of the new General Electric High Speed SCRs such as the C140 and 141, the C155 and C185 @ For Use in: Inverters Sonar Power Supplies Choppers Ultrasonic Systems _ Low RF Interference Applications DC-DC Power Supplies Free-Wheeling Rectifier Applications maximum allowable ratings (Resistive or Inductive Load) 1N3899,R 1N3900,R 1N3901,R 1N3902,R 1N3903,R *Maximum Repetitive Peak Reverse Voltage, T; = 65C to +150C, Vaw (rep) (Note 1)..... 00... eee 50 100 200 300 400 Maximum RMS Voltage, T; = 65C to +150C, V,.......... 35 70 140 210 280 *Maximum DC Blocking Voltage, T; = 65C to +100C, Vi (Note 1) 26. cee eee e tenet n ees 50 100 200 300 400 *Maximum Average Forward Current, Single Phase, Tc = 4100C, Ig oo ce nent ee eens 20 Amperes -> *Maximum Peak One Cycle Surge Current, 60 cycle, Non- Recurrent, T; = 65C to +150C, In, (surge)........... 225 Amperes -___> *Maximum Peak Ten Cycle Surge Current, 60 cycle, Non- Recurrent, T; = 65C to +150C, Ipy (surge)............ -120 Amperes -_+ *Maximum Forward Voltage Drop, I, = 20 ADC, T;. = +25C, Vp ____- 1.4 Volts ___-_____+ *Maximum Reverse Current at Full Load, Single Phase Full- Cycle Average, I, = 20 Amp. at Te = +100C, Tua... ee eee 10.0 mA Maximum Effective Thermal Resistance (Junction to Case), @3.. # 1.5 C/W _> *Maximum DC Reverse Current at Rated DC Blocking Voltage, Via and To = = +100 C, Ip a _-__ OO 6.0 mA *Maximum DC Reverse Current at Rated DC Blocking Voltage, Vr and To = = +25 C, Ih. se we ee ee ee we eh ew ee ee + 50 pA *Junction Operating Temperature Range, T,;................. _ 85C to +150C ____> *Storage Temperature Range, Tap... ee eee _ 65C to +-175C *Stud Torque .... 0... ccc ee eet ete nee _ 30 in-Ibs. Maximum > *Maximum Reverse Recovery Characteristics : ; Recovery Time (Note 2), thy 0... cece ccc cece eee eee 200 Nanoseconds Maximum> Peak Recovery Current (Note 2), I, (recovery) ; (or Overshoot Current, Ios) 2.0... cece eee eas 3.0 Amperes Maximum *The asterisk denotes JEDEC (EIA) registered information. NOTES: 1. The ratings assume the rectifier heatsink thermal resistance to be 6C/W or less at maximum junction temperature. Volts Volts Volts 2. These rectifiers are factory tested to reverse recovery limits which correlate with EIA registered values. This testing is in accord- ance with NEMA-EIA recommendations for silicon rectifier diodes and stacks. Recovery characteristic test co ditions: Ir. 5.0 amps; di/dt 50 amps/usec switching rate, and a reverse bias of 50% Vu for 200, 300 and 400 volt grades or 100% V:, for 50 and 100 volt grades; Te = 25C; = 150 nanoseconds; and Ix: (recovery) = 6.0 amperes max. 2511N3899-3903, R - =- 8 NR wp > @ 89 8 8 & Igtave) AVERAGE FORWARD CURRENT {Ir (avg)! AMPS ns 150 -65 -45 50 70 90 110 Bo 170 T,- CASE TEMPERATURE (Ty )- C 1. Forward Current Rating vs. Case Temperature Note: Case temperature, Tc, is measured at center of any flat on hex base. OUTLINE DRAWING le INCHES MILLIMETERS OIRECTION OF FOWARD CURRENT FLOW: YMBOL! MIN MAX MIN. | MA NOTES 44 FORWARD POLARITY A - _ - x. ~p} REVERSE POLARITY 450 11.43 : TERM. ! b 375 9.53] 2 rie 080 2.03 1 $D 667 16.94 E .667 | 687 | 16.94] 17.45 ' "| F AES .200; 2.92| 5.08 SEATING A _| NOTES: Fy 060 1.52 PLANE , L.COMPLETE THREADS TO EXTEND TO WITHIN 2-1/2 J 1000 2540 THREADS OF SEATING PLANE. : : 2. ANGULAR ORIENTATION OF TERMINAL IS UNDEFINED. 1 156 3.96 4 3.1/4-28 UNF- 2A. MAXIMUM PITCH DIAMETER OF PLATED ' THREADS SHALL BE BASIC PITCH DIAMETER (.2268', 5.74 MM $M | 220 | .249/ 559/ 632| | REF. (SCREW THREAD STANDARDS FOR FEDERAL SERVICES N 422 | 453 | 1o72/ 11.51 1957) HANDBOOK H28 1957 P!. 4. MINIMUM FLAT. pt A4O | 175 | 356 | 4.45 EIA-NEMA STANDARD OUTLINE, NEMA SK-St~ EIA RS-241. WwW 1,3 INSULATING HARDWARE IS AVAILABLE UPON REQUEST. COMPLIES WITH EIA REGISTERED OUTLINE DO-5 252