Eective September 2013
Supersede September 2010
Instruction Leaet IL 70-8749
Figure 1.
Figure 2.
Figure 3.
Device
Lever
Locko
Bracket
DIN-Rail
Locko
Bracket
Foot
Locko
Bracket
Tab
Screw Screwdriver
Right Side
Lever
Padlock
Hole
DIN-Rail
Padlock Hole
FAZ Locko for 1-3 Pole
Supplementary Protectors
FAZPLOFF
CAT. NO. FAZPLOFF
QTY. 1
FAZ Locko for 1-3 Pole
Supplementary Protectors
Installation Instructions
Step 1. (Figure 1) Lift lever and place lockoff bracket to right side of
device.
Step 2. (Figure 1) Position lockoff bracket over DIN-rail, with lockoff
bracket foot aligned on either side of DIN-rail.
Step 3. (Figure 1) Insert the screw in the bracket hole aligned with cir-
cuit breaker bracket hole and tighten with a screwdriver.
Step 4. (Figure 1) Insert lockoff bracket tab under right side of device
while sliding along DIN-rail until stopping as shown in Figure 2.
Step 5. (Figure 2) Close lever so padlock holes are aligned until stop-
ping as shown in Figure 3.
Step 6. (Figure 3) Insert padlock shank through padlock hole and lock
when desired.
Instruction Leaet IL 70-8749
Eective September 2013
FAZ Locko for 1-3 Pole
Supplementary Protectors
Electrical Sector
1000 Eaton Boulevard
Cleveland, OH 44122 USA
United States
877-ETN-CARE (877-386-2273)
Eaton.com
© 2013 Eaton Corporation
All Rights Reserved
Printed in USA
Publication No. IL 70-8749 / 002
September 2013
Eaton is a registered trademark of Eaton
Corporation.
All other trademarks are property of their
respective owners.
This instruction leaflet is published solely for information purposes
and should not be considered all-inclusive. If further information is
required, you should consult an authorized Eaton sales representa-
tive.
The sale of the product shown in this literature is subject to the
terms and conditions outlined in appropriate Eaton selling policies
or other contractual agreement between the parties. This literature
is not intended to and does not enlarge or add to any such contract.
The sole source governing the rights and remedies of any purchaser
of this equipment is the contract between the purchaser and Eaton.
NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR
MERCHANTABILITY, OR WARRANTIES ARISING FROM COURSE
OF DEALING OR USAGE OF TRADE, ARE MADE REGARDING
THE INFORMATION, RECOMMENDATIONS, AND DESCRIPTIONS
CONTAINED HEREIN. In no event will Eaton be responsible to the
purchaser or user in contract, in tort (including negligence), strict
liability or otherwise for any special, indirect, incidental or conse-
quential damage or loss whatsoever, including but not limited to
damage or loss of use of equipment, plant or power system, cost
of capital, loss of power, additional expenses in the use of existing
power facilities, or claims against the purchaser or user by its cus-
tomers resulting from the use of the information, recommendations
and description contained herein.