www.RFM.com E-mail: info@rfm.com Page 1 of 3
©2009-2010 by RF Monolithics, Inc. XTL1003 - 2/3/10
Electrical Characteristics
Characteristic Sym Notes Minimum Typical Maximum Units
Nominal Frequency 13.56000 MHz
Mode of Oscillation Fundamental
Operating Temperature Range -20 +70 °C
Frequency Stability over Operating Temperature Range ±20 ppm (referred to the value at 25 °C)
Frequency Make Tolerance FL± 10 ppm @ 25 °C ±3 °C
Equivalent Series Resistance ESR 40 Ω
Nominal Drive Level 10 uW
Shunt Capacitance CO2.0 pF
Load Capacitance CL20 pF
Motional Capacitance CM4.2 fF ±20%
Aging ±1.0 ppm/year @25 °C
Stanard Shipping Quantity on 330 mm (13”) Reel 3000 units
Lid Symbolization (in addition to Lot and/or Date Codes) 1003 YWWS
24
C r y s t a l E q u i v a l e n t C i r c u i t
ESR
C
O
SM5032-4 Case
13.56000 MHz
Crystal Unit
XTL1003
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. The design, manufacturing process, and specifications of this device are subject to change without notice.
• Surface Mount Se am-Weld Package
• Good Frequency Stability over Temperature
• Excellent Reliability
• Complies with Directive 2002/95/EC (RoHS)
The XTL1003 is a surface mount 5.0 x 3.2 mm crystal unit for use in wireless
telecommunications devi ces, especially where an ultra-miniature package is
needed for mobility.
2 >
www.RFM.com E-mail: info@rfm.com Page 2 of 3
©2009-2010 by RF Monolithics, Inc. XTL1003 - 2/3/10
1.2 ±0.1
2.2 ±0.1
1.2 ±0.1
1.7 ±0.1
Dot Indicates Pin 1
Electrical Connections
Note: Pin #1 & #3 are connected to metal cap on top
Pin Connection
1GND
2IN/OUT
3GND
4IN/OUT
3.2 ±0.1
5.0 ±0.1
0.8 ±0.1
1.4 ±0.2
1.2 ±0.1
2.4 ±0.2
pin 2 pin 3
pin 4
pin 1
0.8 ±0.1
4-Terminal Surface-Mount Seam Weld Case
5.0 x 3.2 mm Nominal Footprint
SM5032-4 Case
Footprint (mm)
Package Orientation in Carrier Tape
Package Dimensions (mm)
1003
YWWS
1003
YWWS
1003
YWWS
Top View
Side View
Bottom View
www.RFM.com E-mail: info@rfm.com Page 3 of 3
©2009-2010 by RF Monolithics, Inc. XTL1003 - 2/3/10
Reel Dimensions
Tape Dimensions
Notes:
1. Unless otherwise specified, tolerance on dimensions is ±0.1 mm
2. Material is black conductive polystyrene
3. 10 pitch cumulative tolerance is ±0.2 mm
