Classification: "Lithium Coin"
Lithium / Manganese Dioxide (Li/MnO2)
Designation: ANSI-5034LC, IEC-CR1216
Nominal Voltage: 3.0 Volts
Typical Capacity: 25 mAh (to 2.0 volts)
(Rated at 62K ohms at 21°C)
Typical Weight: 0.6 grams (0.02 oz.)
Typical Volume: 0.2 cubic centimeters (0.01 cubic inch)
Max Rev Charge: 1 microampere
Energy Density: 118 milliwatt hr/g, 413 milliwatt hr/cc
Typical Li Content: 0.008 grams (0.0003 oz.)
Operating Temp: -30C to 70C
Self Discharge: ~1% / year
62,000 553 Bkgnd Drain: Continuous
Pulse Drain: 2 seconds X 12 times/day
Contents herein do not constitute a warranty and are for reference only.
Pulse Test at 21°C (70°F)
Typical Discharge Characteristics
Internal Resistance Characteristics
This datasheet contains typical information specific to products manufactured at the time of its publication.
Simulated Application test
Industry Standard Dimensions
Typical Performance at 21°C (70°F)
(1) KEEP OUT OF REACH OF CHILDREN. Swallowing may lead to
serious injury or death in as little as 2 hours due to chemical burns and
potential perforation of the esophagus. Immediately see doctor; have
doctor phone (800) 498-8666.
(2) Battery compartment design. To prevent children from removing
batteries, battery compartments should be designed with one of the
following methods: a) a tool such as screwdriver or coin is required to open
battery compartment or b) the battery compartment door/cover requires
the application of a minimum of two independent and simultaneous
movements of the securing mechanism to open by hand. Screws should
remain captive with the battery door or cover.
1.8
2.0
2.2
2.4
2.6
2.8
3.0
3.2
0 100 200 300 400 500 600
Voltage, CCV
Service, Hours
Load: 62,000 ohms - Continuous
Typical Drain @ 2.85V: 0.046 mA
0
10
20
30
40
50
60
70
1.8
2.0
2.2
2.4
2.6
2.8
3.0
3.2
0 5 10 15 20 25
IR, ohms
Voltage, CCV
Capacity, mAh
1.60 (0.063)
1.40 (0.055)
1.40 (0.055) Ref.
1.10 (0.043) Ref.
12.20 (0.480)
12.50 (0.492)
4.00 (0.157)
Minimum
0.30 (0.012) Maximum Ref.
Permissible deflection from a flat.
0.03 (0.001) Minimum Ref.
(Applies to top edge of gasket or
edge of crimp, whichever is higher.)
Form No. 1216GL0618 Page 1 of 1