MIL-PRF-39012/60D
Withdrawal force test:
Steel test pin diameter: .0355 + .0000/-. 000 01 inc h.
Insertion depth: .050/.075 inch
Test pin finish: 16 microinches
Withdrawal force: 1 ounce, minimum
FIGURE 2. Test pin data.
Hermetic seal: Not applicable.
Leakage (pressurized connectors): Not applicable.
Insulation resistance: In accor danc e with test procedure EIA - 364-21, 5,000 mega oh ms mi nimum.
Center contact retention:
Axial force: 6.0 pounds minimum.
Radial torque: 4 inch-ounces minimum.
Solderability: In accordance with MIL-STD-202 (for quality conformance inspection, the test shall be
performed in group B following the insulation resistance test.)
Resistance to test probe damage: Not applicable.
Corrosion (salt spray): In accordance with test procedure EIA - 364-26.
Voltage standing wave ratio (VSWR): Not applicable.
Connector durability: In accordanc e with t est procedure EIA - 364-09, 500 cycles minimum at 12 cycles
per minute maximum. The connector shall meet mating characteristics and force to engage and
disengage requirements.
Contact resistance: In milliohms, maximum.
Initial After environment
Center contact: 3.0 4.0
Outer contact: 2.0 Not applicable
Source: http://assist.dla.mil -- Downloaded: 2021-04-29T16:43ZCheck the source to verify that this is the current version before use.