■
Specifications are subject to change without notice. Specifications in this catalog are for reference. The formal specification sheets will be submitted upon request.
COPAL ELEC
T
R
O
NIC
S
Top adjustment
Side adjustment
Adjustment position
Form of packaging
Taping (Ammo pack type) Plastic bag
※The above part numbers are all available with the respective combination of
<Nominal resistance values> (Fig. 1).
※Verify the above part numbers when placing orders.
※
Taping specification is not sold separately and must be purchased in taping unit.
The products indicated by A mark are manufactured upon receipt of
order basis.
FT-63ETP FT-63EP
FT-63ETV FT-63EV
FT-63ETS FT-63ES
FT-63EX
FT-63ETH FT-63EH
FT-63EN
〈
Nominal resistance values
〉
Fig. 1
A10 ΩA20 Ω50 Ω100 Ω200 Ω300 Ω500 Ω
1 kΩ2 kΩ3 kΩ5 kΩ10 kΩ20 kΩ30 kΩ
50 kΩ100 kΩ200 kΩ300 kΩ500 kΩ1 MΩ2 MΩ
:
Not manufactured
Mechanical angle
Operating torque
Stop strength
Rotational life
Thrust to rotor
Solderability
Terminal strength
Nominal resistance range
Resistance tolerance
Power ratings
Resistance law
Maximum input voltage
Maximum wiper current
Effective electrical angle
End resistance
C.R.V.
Operating temp. range
Temp. coefficient
Insulation resistance
Dielectric strength
Net weight
10 Ω~ 2 MΩ
± 10 %
0.5 W (70 °C) 0 W (125 °C)
Linear law
DC200 V or power rating, whichever is smaller
Power ratings
220 ° (1 turn)
1 % or 2 Ω, whichever is greater
2 % or 3 Ω, whichever is greater
−55 ~ 125 °C
10 Ω~ 20 Ω:±150 10-6/°C maximum
50 Ω~ 2 MΩ:±100 10-6/°C maximum
1000 MΩminimum (DC500 V)
AC900 V, 60 s
Approx. 0.52 g (FT-63EP, EV)
Approx. 0.66 g (FT-63ES, EH, EX, EN)
260 ° (1 turn)
20 mN·m {204 gf·cm} maximum
50 mN·m {510 gf·cm} minimum
100 cycles [
Δ
R/R ≦±(2 Ω+3 %)]
10 N {1.02 kgf} minimum
245 ±3 °C, 2 ~ 3 s
10 N {1.02 kgf} minimum
(
Tensile strength
)
{ }
:
Reference only
■
ELECTRICAL CHARACTERISTICS
■
MECHANICAL CHARACTERISTICS
■
LIST OF PART NUMBERS
FT-63
CERMET TRIMMERS