501-395-4 Qualification Test 18May99 Rev O JAIN F> Report EC 0990-1221-98 AMPOWER?* Quick Disconnect Terminals 1. INTRODUCTION 1.1. Purpose Testing was performed on AMPOWER? quick disconnect terminals to determine their conformance to the requirements of AMP* Product Specification 108-30200-4 Revision A. 1.2. Scope This report covers the electrical, mechanical, and environmental performance of the 1/0 and 2/0 AMPOWER quick disconnect terminals. Testing was performed at the Americas Regional Laboratory between 0O5May98s and 26Aug98. The test file number for this testing is CTL 3261-000-021A. This documentation is on file at and available from the Americas Regional Laboratory. 1.3. Conclusion The AMPOWER quick disconnect terminals listed in paragraph 1.5., conformed to the electrical, mechanical, and environmental performance requirements of AMP Product Specification 108-30200-4 Revision A. 1.4. Product Description The AMPOWER quick disconnect terminals have been specifically designed for use in the transportation industry since they provide a highly reliable and economic means of terminating large power cables and leads. 1.5. Test Samples Test samples were representative of normal production lots. Samples identified with the following part numbers were used for test: Test Group |Quantity | Part Number Description 1 8 696036 Quick disconnect terminal with 1/0 copper wire 8 696037 Quick disconnect terminal with 2/0 copper wire Figure 1 1.6. Environmental Conditions Unless otherwise stated, the following environmental conditions prevailed during testing: Temperature: 15 to 35C Relative Humidity: 20 to 80% AMP Incomorated, Hartisburg, PA This reportis a controlled document. 1 of 4 * Trademark Gepyright 1998 by AMP Incomorated. LOC B | Indicates change All rights reserved. Form 404-56 May98