RANSYS 1N5926B THRU 1N5956B ELECTRONICS GLASS PASSIVATED JUNCTION SILICON ZENER DIODE LIMITED VOLTAGE - 11 TO 200 Volts Power - 1.5 Watts FEATURES DO-41 Low prof e package Built-in strain re ef T 44 486) Glass passivated junction (say 1.0 O28 (7D, Low inductance MIN Typical lp; less than 1 gA above 11V | High temperature soldering : (5.3) 260 J/10 seconds at terminals Ci) wilt = Lal Plastic package has Underwriters Laboratory Flammab ity Classification 94V-O c b aT om (254) Le DIM MECHANICAL DATA Case: JEDEC DO-41 Molded plastic over passivated junction Terminals: Solder plated, solderable per MIL-STD-750, Dimensions in inches and (millimeters) method 2026 Polarity: Color band denotes positive end (cathode) Standard Packaging: 52mm tape Weight: 0.012 ounce, 0.3 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 J ambient temperature unless otherwise specified. SYMBOL VALUE UNITS DC Power Dissipation @ T_=75 J, Measure at Zero Lead Length(Note 1, Fig. 1) Pp 1.5 Watts Derate above 75 J 15 mW/J Peak forward Surge Current 8.3ms single half sine-wave superimposed on rated Irom 10 Amps load(JEDEC Method) (Note 1,2) Operating Junction and Storage Temperature Range Ty, T ste -55 to +150 J NOTES: 1. Mounted on 5.0mm*(.013mm thick) land areas. 2. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum. 3. ZENER VOLTAGE (Vz) MEASUREMENT Nominal zener voltage is measured with the device function in thermal equ ibrium with ambient temperature at 25 J. 4.ZENER IMPEDANCE (Zz) DERIVATION Zz; are measured by dividing the ac voltage drop across the device by the accurrent applied. The specified limits are for Iza.) = 0.1 Iz, (dc) with the ac freqency = 60Hz.1N5926B THRU 1N5956B ELECTRICAL CHARACTERISTICS (T_=30 J unless otherwise noted) (V-=1.5Volts Max @ |-=200mA) Device Nominal Zener | Test current . Max reverse Maximum DC Voltage Vz @ lzt lzr Maximum Zener Impedance (Note 2.) Leakage Current Zener Current volts mA Izu (Note 1.) Zz1 @ Izt Zx @ lex lx Ip Va mAdc Ohms Ohms @ mA gA @ Volts 1N5926B 11 34.1 55 550 0.25 1 8.4 136 1N5927B 12 31.2 6.5 550 0.25 1 9.1 125 1N5928B 13 28.8 7 550 0.25 1 9.9 115 1N5929B 15 25 9 600 0.25 1 11.4 100 1N5930B 16 23.4 10 600 0.25 1 12.2 93 1N5931B 18 20.8 12 650 0.25 1 13.7 83 1N5932B 20 18.7 14 650 0.25 1 15.2 75 1N5933B 22 17 17.5 650 0.25 1 16.7 68 1N5934B 24 15.6 19 700 0.25 1 18.2 62 1N5935B 27 13.9 23 700 0.25 1 20.6 55 1N5936B 30 12.5 26 750 0.25 1 22.8 50 1N5937B 33 11.4 33 800 0.25 1 25.1 45 1N5938B 36 10.4 38 850 0.25 1 27.4 41 1N5939B 39 9.6 45 900 0.25 1 29.7 38 1N5940B 43 8.7 53 950 0.25 1 32.7 34 1N5941B 47 8 67 1000 0.25 1 35.8 31 1N5942B 51 7.3 70 1100 0.25 1 38.8 29 1N5943B 56 6.7 86 1300 0.25 1 42.6 26 1N5944B 62 6 100 1500 0.25 1 47.1 24 1N5945B 68 55 120 1700 0.25 1 51.7 22 1N5946B 75 5 140 2000 0.25 1 56 20 1N5947B 82 4.6 160 2500 0.25 1 62.2 18 1N5948B 91 4.1 200 3000 0.25 1 69.2 16 1N5949B 100 3.7 250 3100 0.25 1 76 15 1N5950B 110 3.4 300 4000 0.25 1 83.6 13 1N5951B 120 3.1 380 4500 0.25 1 91.2 12 1N5952B 130 2.9 450 5000 0.25 1 98.8 11 1N5953B 150 2.5 600 6000 0.25 1 114 10 1N5954B 160 2.3 700 6500 0.25 1 121.6 9 1N5955B 180 2.1 900 7000 0.25 1 136.8 8 1N5956B 200 1.9 1200 8000 0.25 1 152 7 * TOLERANCE AND VOLTAGE DESIGNATION Tolerance designation - tolerance of 505% RATING AND CHARACTERISTICS CURVES 1N5926B THRU 1N5956B PD, MAXIMUM POWER DISSIPATION (WATTS) Fig 0 20 40 60 80 100 120 140 150 180 3 4 cVZ, TEMPERATURE COEFFICIENT(mV/J) TL, LEAD TEMPERATURE (J) . 1-STEADY STATE POWER DERATING VZ@IZT 6 The type numbers. sted indicate a 8 10 VZ, ZENER VOLTAGE (VOLTS) Fig. 2-ZENER VOLTAGE-TO 12 VOLTSRATING AND CHARACTERISTICS CURVES 1N5926B THRU 1N5956B c VZ, TEMPERATURE COEFFICIENT(mV/J) VZ@IZT 10 20 30 50 70 100 200 VZ, ZENER VOLTAGE (VOLTS) Fig. 3-ZENER VOLTAGE-10 TO 200 VOLTS ZZ, DYNAMIC IMPEDANCE (OHMS) IZ, ZENER CURRENT (mA) IZ (ms) =0.1 IZ (do) 5 7 10 20 30 50 70 100 VZ, ZENER VOLTAGE (VOLTS) 2 999 on ny wo o o ~ 10 VZ, ZENER VOLTAGE (VOLTS) Fig. 7-VZ =6.8 THRU 10 VOLTS ZZ, DYNAMIC IMPEDANCE (OHMS) PPK, PEAK SURGE POWER IZ, ZENER CURRENT (mA) x TJ-25J IZ(ms) = 0.1 IZ(de) 8 3 N Q oa VZ = 150V rot 2 ao 91V a oO 62V = NY Oo 0 22 yn oO 6.8V ot oa 2 5 10 20 50 100 200 500 IZ, ZENER TEST CURRENT (mA) Fig. 44 EFFECT OF ZENER CURRENT TTANGULAR NONREPETITIVE AVEFORM Td = 253) PRIOR TO an ITIAL PULSE p <x = 1623 5 1 235 10 2 50 = 100 PW, PULSE WIDTH(ms) 1 1 1 0. 0. 0. 0 0 10 20 30 40 50 60 7080 90 100 VZ, ZENER VOLTAGE (VOLTS) Fig. 8-VZ = 12 THRU 82 VOLTS