SPECIFICATION CONTROL DRAWING
DEVICES Raychem Inter connect
300 Constitution Drive
Menlo Park, CA 94025
USA
TITLE: SEALING SLEEVE FOR SHIELD
TERMINATIONS
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS. DOCUMENT NO.: D-438-0101/-0105
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
Raychem reserves the right to amend this
drawing at any time. Users should evaluate the
suitability of the product for their application.
DCR NUMBER:
D990849 REPLACES: N/A
DRAWN BY:
M. FORONDA DATE: 10/05/99 PROD. REV.:
SEE TABLE DOC ISSUE:
0 SCALE:
None SIZE:
A SHEET:
1 of 1
If this document is printed it becomes uncontrolled. Check for the latest revision.
Product Revision Product Dimensions Cable Dimensions
Product Name L±1.75
(L±0.07) øA
min. øB
min. øC
min. øD
MAX øE
MAX øF
min. øG
min.
D-438-0101 A 16.5
(0.650) 1.90
(0.075) 2.65
(0.105) 8.25
(0.325) 1.90
(0.075) 2.65
(0.105) 0.90
(0.035) 0.50
(0.020)
D-438-0102 A 16.5
(0.650) 2.65
(0.105) 3.68
(0.145) 8.25
(0.325) 2.65
(0.105) 3.68
(0.145) 1.40
(0.055) 0.72
(0.030)
D-438-0103 A 16.5
(0.650) 4.30
(0.170) 5.08
(0.200) 8.25
(0.325) 4.30
(0.170) 5.08
(0.200) 2.15
(0.085) 1.25
(0.050)
D-438-0104 A 19.1
(0.750) 5.95
(0.235) 6.45
(0.255) 8.25
(0.325) 5.95
(0.235) 6.45
(0.255) 3.30
(0.130) 1.80
(0.070)
D-438-0105 A 19.1
(0.750) 7.00
(0.275) 7.60
(0.300) 8.25
(0.325) 7.00
(0.275) 7.60
(0.300) 4.30
(0.170) 2.50
(0.100)
MATERIALS
1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene fluoride.
2. MELTABLE RINGS: Environment resistant thermoplastic. Color: blue.
APPLICATION
1. These parts are designed to provide an environment resistant seal of hand soldered shield terminations on cables meeting the
following criteria:
Dimensions: Per table. Jacket rating: 125°C.
Jacket material: See M83519/1 or consult Raychem.
2. To assemble part prepare cable as shown in diagram, make termination, center the termination window between the inserts in the
sleeve, apply heat until sleeve recovers and inserts melt and flow. Be careful not to reflow solder during sleeve installation.
3. Prepare the cable as shown:
