07-2012, Rev. 0712
www.te.com
© 2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. company
Datasheets and product specification
according to IEC 61810-1 and to be used
only together with the ‘Definitions’ section.
Datasheets and product data is subject to the
terms of the disclaimer and all chapters of
the ‘Definitions’ section, available at
http://relays.te.com/definitions
Datasheets, product data, ‘Definitions’ sec-
tion, application notes and all specifications
are subject to change.
3
AXICOM
Socket Size I Size II Size III
Dimension a and b 27mm 33mm 39mm
Dimension c 42mm 48mm 54mm
Signal Relays
Telecom-, Signal- and RF Relays
Cradle Relay Accessories and Mounting (Continued)
Dimensions
Minimum spacings between sockets
with hold-down spring for cradle relays N, S and P for cradle relay P
Relays oriented in the same direction
Relays oriented inversely to each other
When mounting cradle relay P consideration should be
given to magnetic fields. Strong DC magnetic fields, possibly
caused by adjacent relays,and large iron masses are the
most common causes of interference. Experience has
shown that under normal operating conditions the minimum
spacings specified for cradle relay P are sufficient to prevent
cross interference.
Mounting hole layout for cradle relays and sockets with hand solder
terminals
with hold-down spring for cradle relays N, S and P
Size I Size II Size III
*) This hole is omitted when mounting hole layouts is intended for the socket
a