Rev.06.27.07
SMT10F_12
3 of 5
Embedded Power for
Business-Critical Continuity
All specifications are typical at nominal input, full load at 25°C unless otherwise stated.
Specifications
Notes
1 The SMT10F-12 features an ‘Positive Logic’ Remote ON/OFF operation. If not
using the Remote ON/OFF pin, leave the pin open (the converter will be on).
The Remote ON/OFF pin is referenced to ground.
The following conditions apply for the SMT10F-12:
Configuration Converter Operation
Remote pin open circuit Unit is ON
Remote pin pulled low Unit is OFF
Remote pin pulled high Unit is ON
2 The complete range of 0.8V to 3.6V is not available in a single unit. In the
SMT10F-12S1V0 the coverage is from 0.8V to 1.65V and in the SMT10F-
12S3V0 the coverage is from 1.66V to 3.6V. The output voltage in both cases
is set by an external resistor. The current in the resistor is 28.7μA, hence
typical values of resistence from the E-96 range are shown in Table 1.
3 Output external capacitance is required for basic operation. Required
capacitance is a minimum of 264μF to meet performance parameters. This
can be made up of any combination of 22μF or 44μF MLCC. For best
performance they need to be very close to the SMT10 and connected by wide
traces, ideally by ground planes. The use of low ESR and low ESL components
is important.
4 Frequency is a function of Vin and Vout. It varies between 500kHz and 1MHz.
5 TSE RoHS 5/6 (non Pb-free) compliant versions may be available on special
request, please contact your local sales representative for details.
6 NOTICE: Some models do not support all options. Please contact your local
Artesyn representative or use the on-line model number search tool at
http://www.artesyn.com/powergroup/products.htm to find a suitable
alternative.
SMT10F-12W3V3J
Part Number System with Options
Product Family
SMT = Surface Mount
Rated Output Current
10 = 10 Amps
Input Voltage
12 = 7.5-13.2 Vdc
Type of Output
S = Single Fixed
W = Wide
Performance
F = Enhanced/Fast Transient
Performance
OUTPUT INPUT OUTPUT OUTPUT OUTPUT EFFICIENCY REGULATION MODEL
POWER VOLTAGE VOLTAGE (2) CURRENT CURRENT (TYP.) LINE LOAD NUMBER (1,5,6)
(MAX.) (MIN.) (MAX.)
16.5 W 7.5-13.2 V 0.8-1.65 V 0 A 10 A 86% ±1.0% ±1.0% SMT10F-12W1V0J
33 W 7.5-13.2 V 1.66-3.6 V 0 A 10 A 91% ±1.0% ±1.0% SMT10F-12W3V3J
Output Voltage Range
1V0 = 0.8-1.65 Vdc
3V3 = 1.66-3.6 Vdc