Snap-In Enclsoures Specifications: Material : High impact of UL94-HB ABS. Ligh grey and black colors are available for selection. Snap-in design can be opened and closed easily without the tool. Rubber of the cable entry can be cut by knife easily for the cable connection. 4 PCS of internal bosses are available for pcb assembly. Ideally use for indoor/outdoor telecommunication device. http://www.farnell.com http://www.newark.com http://www.cpc.co.uk Page <1> 03/01/11 V1.1 Snap-In Enclsoures GH001G;GH001B Lid Base Rubber Dimensions : Millimetres GH002G;GH002B Lid Base Rubber Dimensions : Millimetres http://www.farnell.com http://www.newark.com http://www.cpc.co.uk Page <2> 03/01/11 V1.1 Snap-In Enclsoures Part number Table Description Box, ABS, 45X79X91MM, GRY Cable Entry External Dimension (mm) Part Number Length 1 Way Width Height 79 45 Box, ABS, 45X79X91MM, BLK GH001G GH001B 91 Box, ABS, 69X122X91MM, GRY 2 Way GH002G 122 Box, ABS, 69X122X91MM, BLK 69 GH002B Disclaimer This data sheet and its contents (the "Information") belong to the Premier Farnell Group (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. SPC Multicomp is the registered trademark of the Group. (c) Premier Farnell plc 2010 http://www.farnell.com http://www.newark.com http://www.cpc.co.uk Page <3> 03/01/11 V1.1