HS271DR Series Assemblies
•
25 amp AC output @ 40°C
•
Single Channel output
•
3 to 32 VDC input control voltage
•
DIN Rail mounted
•
uL, CSA, VDE, CE approved SSRs
PRODUCT SELECTION
Description 25 A 25 A
3-32 VDC Control HS271DR-D2425 HS271DR-HD6025
OUTPUT SPECIFICATIONS (1)
Description HS271DR-D2425 HS271DR-HD6025
Operating Voltage (47-63Hz) [Vrms] 24-280 48-660
Transient Overvoltage [Vpk] 600 1200
Maximum Off-State Leakage Current @ Rated Voltage [mArms] 10 10
Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) 500 500
Maximum Load Current [Arms] 25 25
Minimum Load Current [Arms] 0.04 0.04
Maximum Surge Current (16.6ms) [Apk] 250 250
Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.6 1.7
Maximum I²t for Fusing (8.3 msec) [A² sec] 260 260
Minimum Power Factor (with Maximum Load) 0.5 0.5
INPUT SPECIFICATIONS (1)
Description HS271DR-D2425 HS271DR-HD6025
Control Voltage Range 3-32 VDC 3-32 VDC
Minimum T urn -On Voltage 4.0 VDC 4.0 VDC
Minimum Tu rn -Of f Volta ge 1.0 VDC 1.0 VDC
Maximum Reverse Voltage 32 VDC 32 VDC
Typical Input Current 3.4 mA @ 5 VDC 2.0 mA (3)
Nominal Input Impeadance 1500 Ohms (3)
Maximum Turn-On Time [msec] 1/2 Cycle 1/2 Cycle
Maximum Turn-Off Time [msec] 1/2 Cycle 1/2 Cycle
GENERAL SPECIFICATIONS
Description Parameters
Dielectric Strength, Input/Output/Base (50/60Hz) 4000 Vrms
Minimum Insulation Resistance (@ 500 V DC) 109 Ohms
Maximum Capacitance, Input/Output 8 pF
Ambient Operating Temperature Range -40 to 80ËšC
Ambient Storage Temperature Range -40 to 125ËšC
Status Indicator Display None
Weight (typical) 0.70 lb. (319g)
Encapsulation Themall y Conductive Epoxy
Recommended Terminal Screw Torque Range: 6-32 Screws - 10 in/lbs. 8-32 Screws - 20 in/lbs.
(Screws dry without grease)
Thermal pad installed Yes
GENERAL NOTES
1) All parameters at 25°C unless otherwise specified.
2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1
3) Input circuitry for DC control version incorporates active current limiter (HD model only)
MECHANICAL SPECIFICATIONS
THERMAL DERATE INFORMATION
AGENCY APPROVALS
Designed in accordance with the requirements of IEC 62314
A
gency approvals are for relay only.
E116949 (D2425) E116950 (HD6025) LR81689 10143 UG
Rev. 110411
ANNEX - ENVIROMENTAL INFORMATION
