https://www.phoenixcontact.com/us/products/1607703 Sleeve housing-VC-K-T2-Z-FK-6X20,5-1607703 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Sleeve housing, plastic, type: VC2, with 6 x 20.5 mm flat cable outlet, locking screws with positive/negative head, The figure shows version VC-K-T3-Z Key Commercial Data Packing unit 1 pc Minimum order quantity 10 pc GTIN GTIN 4017918952914 Weight per Piece (excluding packing) 61.990 g Custom tariff number 85389099 Country of origin Poland Technical data Dimensions Height 65 mm Ambient conditions Degree of protection IP54 Ambient temperature (operation) -40 C ... 80 C General Type VC2 Degree of protection IP54 Flammability rating according to UL 94 V0 03/22/2021Page1/5 https://www.phoenixcontact.com/us/products/1607703 Sleeve housing-VC-K-T2-Z-FK-6X20,5-1607703 Technical data General Locking type Screw locking, cylinder head Fixing screws M4 Tightening torque, mounting screw 1.5 Nm 0.3Nm Type of the screw connection 6 x 20.5 mm Cable outlet straight Housing material PA Seal material EPDM Ambient temperature (operation) -40 C ... 80 C Standards and Regulations Flammability rating according to UL 94 V0 Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. * WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. * WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. * The products are suitable for applications in plant, controller, and electrical device engineering. * When operating the connectors in outdoor applications, they must be separately protected against environmental influences. * Assembled products may not be manipulated or improperly opened. * Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). * When using the product in direct connection with third-party manufacturers, the user is responsible. * For operating voltages > 50V AC, conductive connector housings must be grounded * Ensure that the protective or functional ground has been properly connected. * VDE 0100/1.97 411.1.3.2 and DIN EN 60 204/11.98 14.1.3 are applicable when combining several circuits in a cable and/or connector * Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product * Only use tools recommended by PhoenixContact 03/22/2021Page2/5 https://www.phoenixcontact.com/us/products/1607703 Sleeve housing-VC-K-T2-Z-FK-6X20,5-1607703 Technical data Standards and Regulations * The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. * Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products * Operate the connector only when it is fully plugged in. * Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. * Observe the minimum bending radius of the cable. Lay the cable without twisting it. Environmental Product Compliance China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values Classifications eCl@ss eCl@ss 10.0.1 27440202 eCl@ss 11.0 27440202 eCl@ss 4.0 27140800 eCl@ss 4.1 27140800 eCl@ss 5.0 27143400 eCl@ss 5.1 27261200 eCl@ss 6.0 27261200 eCl@ss 7.0 27440202 eCl@ss 9.0 27440202 ETIM ETIM 2.0 EC000007 ETIM 3.0 EC000007 ETIM 4.0 EC000437 ETIM 6.0 EC000437 ETIM 7.0 EC000437 UNSPSC UNSPSC 6.01 31261501 UNSPSC 7.0901 31261501 UNSPSC 11 31261501 UNSPSC 12.01 31261501 03/22/2021Page3/5 https://www.phoenixcontact.com/us/products/1607703 Sleeve housing-VC-K-T2-Z-FK-6X20,5-1607703 Classifications UNSPSC UNSPSC 13.2 31261501 UNSPSC 18.0 31261501 UNSPSC 19.0 31261501 UNSPSC 20.0 31261501 UNSPSC 21.0 31261501 Approvals Approvals Approvals EAC Ex Approvals Approval details EAC B.01742 Accessories Accessories Protective cover Protective covers-VC-SD1-1853670 Protective cover, Protective covers, type: VC1, housing material: PA 6, color: gray 03/22/2021Page4/5 https://www.phoenixcontact.com/us/products/1607703 Sleeve housing-VC-K-T2-Z-FK-6X20,5-1607703 Accessories Protective covers-VC-SD-T1-1886728 Protective cover, Protective covers, type: VC1, housing material: PA 6, color: gray Phoenix Contact 2021 (c) - all rights reserved http://www.phoenixcontact.com 03/22/2021Page5/5