LS4117, 4118, 4119 ULTRA-HIGH INPUT IMPEDANCE N-CHANNEL JFET Linear Integrated Systems FEATURES LOW POWER IDSS<90 A (2N4117) MINIMUM CIRCUIT LOADING IGSS<1 pA (2N4117A Series) ABSOLUTE MAXIMUM RATINGS (NOTE 1) @ 25C (unless otherwise noted) Gate-Source or Gate-Drain Voltage (NOTE 1) Gate-Current Total Device Dissipation (Derate 2mW/C to 175C) Storage Temperature Range Lead Temperature (1/16" from case for 10 seconds) G -40V 50mA SD BVGSS VGS(off) Gate-Source Cutoff Voltage IDSS Saturation Drain Current 0.03 (NOTE 2) FN4117/A 0.015 Common-Source Forward 70 Transconductance (NOTE 2) Common-Source Output -Conductance Common-Source Input -Capacitance Common-Source Reverse -Transfer Capacitance Ciss Crss 3 1 4 SC TO-72 Bottom View 255C "A" Series only Gate-Source Breakdown Voltage gos 2 300mW -65C to +175C ELECTRICAL CHARACTERISTICS @ 25C (unless otherwise noted) 2N4117/A 2N4118 FN4117/A 2N4118A SYMBOL CHARACTERISTICS MIN MAX MIN MAX Gate Reverse Current --10 --10 IGSS Standard only --25 --25 IGSS Gate Reverse Current --1 --1 gfs Case G D --40 -0.6 -2.5 -- --40 -2.5 -- 2N4119 2N4119A MIN MAX --10 --25 --1 --40 -2.5 -- -1.8 -1 -3 -2 -6 0.09 0.08 0.24 0.20 0.60 210 80 250 100 330 3 -- 5 -- 10 3 -- 3 -- 3 1.5 -- 1.5 -- 1.5 UNITS pA nA pA CONDITIONS VGS= -20V VDS= 0 150C VGS=-20V VDS= 0 150C nA V mA IG=-1A VDS= 0 VDS=10V ID= 1nA VDS=10V VGS= 0 mho f=1kHz VDS= 10V pF VGS= 0 f=1MHz NOTES: 1. Due to symmetrical geometry, these units may be operated with source and drain leads interchanged. 2. This parameter is measured during a 2 ms interval 100 ms after power is applied. (Not a JEDEC condition.) Linear Integrated Systems 4042 Clipper Ct., Fremont, CA 94538 TEL: (510) 490-9160 * FAX: (510) 353-0261