Aleph OH-118-A5 Opto Sensor
Electrical/Optical Characteristics (Ta=25
°C)
Item Symbol Conditions Min Typ Max Unit
Operating Voltage VCC 4.5 –5.5 V
Consumption Current ICC VCC=5V, VOUT=OPEN (average value) ––15 mA
Output Voltage, Low VOL IOUT=16mA –0.1 0.4 V
Output Voltage, High VOH VCC=5V 4.9 – – V
Response Time
tFHL
Note 1
– – 1.0 ms
tFLH – – 1.0 ms
Detecting Output Low when Detecting
Detecting Distance
VCC=5V 90% Reflection Paper (Kodak) 5 ±4 mm
VCC=5V Value N5.5 color chip (non-glossy) 5 ±2 mm
Ambient Luminance 3,000 LUX Max. Incandescent lamp or 50 – 60 Hz Fluorescent Lamp
Note 1:
Mechanical Characteristics
Vibration
Resistance
To withstand 10~55~10Hz, 1.5mm amplitude and 1 minute sweep time in X, Y and Z directions, each for
2 hours.
Shock Resistance 294m/S2 (30G) or more.
Tightening Torque 4 kgf·cm (0.392 N·m Max (By hand or electric driver)
Outer Dimensions
Home
Components
Auto Sensors
Flow Sensors
Level Sensors
Opto Sensors
Application Notes
Actuators
Interruptors
Reflectives
OH-117-A5
OH-118-A5
OH-217-A5
OH-317-A5
OH-1021
OM-371-A8
OM-819
ON-171-A8
Proximity Sensors
Reed Switches
Reed Relays
Intrusion Detection
Video Surveillance
About Us
Contact Us
Home Components Intrusion Detection Video Surveillance About Us Contact Us
Connection Diagram
Components
No. Description Qty. Materials Remarks
1Case 1PBT (G15%) Flammability: UL94V-2 or more
2Case 1PBT (G15%) Flammability: UL94V-2 or more
3Lens 1Acryl Resin UL-94HB
4Connector 1175768-3 AMP (Natural)
5Printed Circuit Board 1FR-4, CEM-3 UL-94V-0
Handling Notes
1. Careful attention should be made to avoid deformation of components.
2. Environmental air must be free from corrosive gasses such as hydrogen sulfide or salt water air.
3. Mount sensor away from direct sunlight and incandescent light.
4. The side with emitting and receiving elements should be handled very carefully.
5. Do not wash sensors. Liquid may get into the case and cause damage. If you must clean the surface area, use a soft
cloth damped with a washing fluid such as methanol or isopropyl alcohol.
6. Degrading LED radiant power should be addressed if sensor is used repeatedly over a long period of time.
7. This product was designed for use in the following applications:
OA equipment, video equipment, consumer electronics, communication equipment, measuring equipment, and control
equipment.
When designing a system for safety and reliability, be sure to incorporate fail-safe and other appropriate measures
